Brother 885-X01 Kullanım Kılavuzu - Sayfa 17

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

While holding the thread from the spool

5

with your right hand, pass the thread

toward you, in the groove on the thread

guide.

• Make sure that the spring in the groove

catches the thread.

1 Spring

Feed the upper thread as shown in the

6

following illustration.

Make sure you guide the thread through

7

the thread take-up lever from right to left

as shown in the following illustration.

1 Thread take-up lever

Memo

● If the thread take-up lever is lowered, the

upper thread can not be wrapped around

the thread take-up lever. Make sure you

raise the needle by turning the handwheel

toward you (counterclockwise) so that the

mark on the wheel points up.

1

1

Put the thread behind the guide above the

8

needle.

• The thread can easily be passed behind the

needle bar thread guide by holding the

thread in your left hand, then feeding the

thread with your right hand.

1 Needle bar thread guide

Thread the needle from front to back

9

leaving a thread tail of about 5 cm

(2 inches).

• If your sewing machine is equipped with a

needle threader, use the needle threader to

thread the needle (see next section).

1

1 5 cm (2 inches)

Note

● Make sure you raise the presser foot lever

and the thread take-up lever before you feed

the upper thread.

● If you incorrectly feed the thread you may

cause sewing problems.

1

16

1