Brother 885-X03 Kullanım Kılavuzu - Sayfa 13

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

CAUTION

●

We designed the bobbin that comes with this machine. If you use bobbins from other models,

the machine will not work properly. Only use the bobbin that comes with this machine or

bobbins of the same type (part code: SA156, SFB: XA5539-151). Using other bobbins may

cause damage to the machine.

1

1 Pull the thread

in completely.

Pull up the spool pin and put a spool of

1

thread on this pin.

While holding the thread from the spool

2

with your right hand, pass the thread

toward you, in the groove on the thread

guide. Then, pass the thread around the

pre-tension disk and pull the thread in

completely.

11.5 mm

(7/16 inch)

1 Pre-tension disk

Actual size

This model

Other models

2 Bobbin winder shaft

1

1 Pre-tension disk

CAUTION

●

If the spool of thread is in the wrong

place, or is set incorrectly, the thread

may tangle on the spool pin.

3

3 Bobbin

1

2

12