Garmin GPSMAP 500 Series Pilot El Kitabı - Sayfa 11

Aviyonik Ekran Garmin GPSMAP 500 Series için çevrimiçi göz atın veya pdf Pilot El Kitabı indirin. Garmin GPSMAP 500 Series 28 sayfaları. Flat-mount kit
Ayrıca Garmin GPSMAP 500 Series için: Talimatlar Kılavuzu (6 sayfalar), Pilot El Kitabı Eki (27 sayfalar), Hızlı Referans Kılavuzu (2 sayfalar), Referans Kılavuzu (2 sayfalar), Talimatlar Kılavuzu (28 sayfalar), Şablon (2 sayfalar), Şablon (1 sayfalar), Yapılandırma Kılavuzu (2 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Kullanıcı El Kitabı (38 sayfalar), Kullanıcı El Kitabı (44 sayfalar), Kurulum Talimatları Kılavuzu (34 sayfalar), Hızlı Referans Kılavuzu (2 sayfalar)

Sayfayı Yazdır
Garmin GPSMAP 500 Series Pilot El Kitabı

Clearing the Map Page

Routinely clearing the Map Page of all discharge points
is a good way to determine if a storm is building or
dissipating. In a building storm discharge points reappear
faster and in larger numbers. In a dissipating storm
discharge points appear slower and in smaller numbers.
Clearing the Map Page of all discharge
points:
1)
From the default Nav Page, turn the small right
knob to select the Map Page.
Press the MENU Key to display the Page
2)
Menu.
3)
Turn the small right knob to select 'Clear Storm
Data?' (Figure 2-4).
Figure 2-4 Map Page Menu
Press the ENT Key.
4)
190-00140-10 Rev. E

Storm Data Display Range

Storm data can be displayed on the 2000 nm zoom
scale, but the data only goes out as far as the STORMSCOPE
can report (200 nm).
North Up Mode: Since the range for Stormscope data
is 400 nm diameter total (200 nm in front and 200 nm
behind), the 500 nm range in North Up mode shows all
the data.
Track Up Mode: In the Track Up mode at the 500
nm range, a portion of Stormscope lightning data can be
behind ("aft" of) the aircraft and therefore not visible on
the Navigation Map.
Selecting a storm data display range:
From the default Nav Page, turn the small right
1)
knob to select the Map Page.
2)
Press the MENU Key to display the Page Menu.
3)
Turn the small right knob to select 'Setup Map?'.
Press the ENT Key.
4)
5)
Turn the small right knob to select the Weather
Group.
Press the ENT Key.
6)
Turn the large right knob to select the desired
7)
lightning symbol option.
8)
Turn the small right knob to select the desired
range (Figure 2-5).
9)
Press the ENT Key.
400/500 Series Display Interfaces
SECTION 2
STORMSCOPE INTERFACE
Figure 2-5 Range Window
2-3