Garmin echomap 40 series Pilot El Kitabı - Sayfa 17

Deniz GPS Sistemi Garmin echomap 40 series için çevrimiçi göz atın veya pdf Pilot El Kitabı indirin. Garmin echomap 40 series 22 sayfaları. Vhf comm
Ayrıca Garmin echomap 40 series için: Kurulum Talimatları Kılavuzu (15 sayfalar), Kullanıcı El Kitabı (32 sayfalar), Uygunluk Beyanı (1 sayfalar), Kullanıcı El Kitabı (30 sayfalar), Kullanıcı El Kitabı (50 sayfalar)

Noise Level

The Noise Level function shows the relative received noise level of the frequency you are listening

to. The range displayed is between 0 and 255. The value will constantly change as you are viewing it as

signal conditions change.

The Headphone Level function allows you to adjust the headphone audio level. Turn the Small knob

to change the value. Setting the value to 0 slaves the headphone audio level to the volume control knob.

The range is from 0 to 255.

The input level required to break squelch by the microphone is set from this page. Lower numbers

indicate a higher input level necessary to break squelch. Turn the Small knob to change the value. The

range is from 0 to 127.

The Transmit Microphone page allows you to control which microphone is permitted to transmit. You

may choose Mic 1, 2, or both. To adjust the Transmit Mic control:

1. Press and hold the MON button for about two seconds. This will access the System Functions mode.

2. Rotate the Large knob to display the Transmit Mic page.

3. Rotate the Small knob to select MIC1, MIC2, or MIC1+MIC2.

4. Press any key to exit the Setup Functions mode.

5. Select an appropriate frequency, key the transmitter, and talk into the microphones to check for the

intended operation.

Detailed Operation

System Functions

NOISE

017

Noise Level

Hdphone Lvl

100

Noise Level

Mic1 Sqlch

100

Mic Squelch Level

Transmit Mic 1

Transmit Mic Selection