Garmin FLEET 790 Kullanıcı El Kitabı - Sayfa 5

Deniz GPS Sistemi Garmin FLEET 790 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Garmin FLEET 790 27 sayfaları.

Sayfayı Yazdır

Getting Started

See the Important Safety and Product Information guide in the

product box for product warnings and other important

information.

• Update the maps and software on your device

Maps and Software Using a Wi

• Mount the device in your vehicle and connect it to power

(Mounting and Powering the Garmin fleet Device in Your

Vehicle, page

1).

• Align the dash camera.

• Acquire GPS signals

(Acquiring GPS Signals, page

• Adjust the volume

(Adjusting Sound and Notification Volume,

page

16) and display brightness

Brightness, page

2).

• Set up a vehicle profile

(Adding a Vehicle Profile, page

• Navigate to your destination

Garmin fleet Overview

Microphone for hands-free calling

Microphone for dash camera recording

Volume control

Camera

Camera flash

Power key

Micro USB power and data port

Map and data memory card slot

3.5mm audio jack

Magnetic mount interface with 14 pin connector

Speaker

Getting Started

WARNING

(Updating

‑ Fi Network, page

17).

2).

(Adjusting the Screen

(Starting a Route, page

Mounting and Powering the Garmin fleet

Device in Your Vehicle

This product contains a lithium-ion battery. To prevent the

possibility of personal injury or product damage caused by

battery exposure to extreme heat, store the device out of direct

sunlight.

Both the device and its mount contain magnets. Under certain

circumstances, magnets may cause interference with some

internal medical devices, including pacemakers and insulin

pumps. Keep the device and its mount away from such medical

devices.

Both the device and its mount contain magnets. Under certain

circumstances, magnets may cause damage to some electronic

devices, including hard drives in laptop computers. Use caution

2).

when the device or its mount is near electronic devices.

4).

Before you use your device on battery power, you should charge

it.

Plug the vehicle power cable

mount.

Press the mount

place.

NOTE: The mount and suction cup may already be

assembled in the package.

The Garmin

easiest to connect the mount and suction cup when the

hinged arm on the suction cup is closed. The mount and

suction cup fit tightly, and you may need to press hard to

connect them.

Press the suction cup to the windshield, and flip the lever

back toward the windshield.

Place the back of the device onto the magnetic mount.

Select an option:

• If your power cable has a vehicle power plug, plug it into a

power outlet in your vehicle.

• If your power cable has bare wire connectors, follow the

wiring diagram included with your cable to connect the

cable to vehicle power.

Turning the Device On or Off

• To turn the device on, press the power key, or connect the

device to power.

• To put the device in power saving mode, press the power key

while the device is on.

While in power saving mode, the screen is off and the device

uses very little power, but it can wake instantly for use.

TIP: You can charge your device faster by putting it in power

saving mode while charging the battery.

• To turn off the device completely, hold the power key until a

prompt appears on the screen, and select Off.

WARNING

NOTICE

into the mini-USB port on the

onto the suction cup

logo on the mount should face right-side up. It is

until it snaps into