Garmin Forerunner 210 Kurulum Talimatları Kılavuzu - Sayfa 2

Deniz GPS Sistemi Garmin Forerunner 210 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Garmin Forerunner 210 19 sayfaları. Gps-enabled sports watch
Ayrıca Garmin Forerunner 210 için: Kullanıcı El Kitabı (28 sayfalar), Hızlı Başlangıç Kılavuzu (13 sayfalar), Önemli Güvenlik Talimatları Kılavuzu (36 sayfalar), Talimatlar Kılavuzu (25 sayfalar), Uygunluk Beyanı (6 sayfalar), Hızlı Başlangıç Kılavuzu (13 sayfalar), Kullanıcı El Kitabı (18 sayfalar)

Tools Needed

• Drill

◦ Bail mount: drill bits appropriate for the surface and hardware

◦ Flush mount: 14 mm (

bit (with no nut plate)

• #2 Phillips screwdriver

• Jigsaw or rotary tool

• File and sandpaper

• Marine sealant (recommended)

This device should be mounted in a location that is not exposed to extreme temperatures or conditions. The

temperature range for this device is listed in the product specifications. Extended exposure to temperatures

exceeding the specified temperature range, in storage or operating conditions, may cause device failure.

Extreme-temperature-induced damage and related consequences are not covered by the warranty.

When selecting a mounting location, you should observe these considerations.

• The location should provide optimal viewing as you operate your boat.

• The location should allow for easy access to all device interfaces, such as the keypad, touchscreen, and card

reader, if applicable.

• The location must be strong enough to support the weight of the device and protect it from excessive

vibration or shock.

• To avoid interference with a magnetic compass, the device should not be installed closer to a compass than

the compass-safe distance value listed in the product specifications.

• The location must allow room for the routing and connection of all cables.

• The location must not be a flat, horizontal surface. The location should be in a vertical angle.

The location and viewing angle should be tested before you install the device. High viewing angles from

above and below the display may result in a poor image.

in.), 6 mm (

in.) and 3.6 mm (

in.) (with nut plate), or 3.2 mm (

NOTICE

in.) drill