Garmin GPSMAP 17 Kurulum Talimatları Kılavuzu - Sayfa 8

Deniz GPS Sistemi Garmin GPSMAP 17 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Garmin GPSMAP 17 19 sayfaları. Gps receiver/antenna
Ayrıca Garmin GPSMAP 17 için: Kurulum Talimatları Kılavuzu (16 sayfalar), Kurulum Talimatları Kılavuzu (12 sayfalar), Kurulum Kılavuzu (16 sayfalar), Referans Kılavuzu (1 sayfalar), Teknik Referans (30 sayfalar), Kurulum Talimatları Kılavuzu (17 sayfalar), Uygunluk Beyanı (1 sayfalar), Teknik Özellikler (40 sayfalar), Hızlı Başlangıç Kılavuzu (16 sayfalar)

NSTALLATION

NSTRUCTIONS

Wiring and Cables

The GPSMAP 3006C/3010C comes with an 18-pin Power/NMEA and a 17-pin Marine Video cable. Optional Garmin Marine Network

components use specialized Garmin Network cables. For some installations, it may be necessary to drill 1.25" (31.7 mm) holes to route the

connector end of the cables. Garmin rubber grommets are provided to cover the installation holes (see below). Wiring instructions are found

on the following pages. If you experience difﬁculty installing the unit, contact Garmin Product Support or seek the assistance of a

professional installer.

The grommets may not be needed in some installations. The grommets do NOT create a waterproof seal. Apply a marine sealant after

installation to weatherproof around the grommet and cable. Additional grommets can be purchased from your Garmin dealer or direct from

Garmin. Be sure to test the system before installing the grommets.

Tools

• Drill

• 1.25" (31.7 mm) paddle drill bit or hole saw

• Utility knife

• Marine sealant (optional)

To install the Cable Grommet:

1. Mark the location where the cable Power/Data, Marine Video, or Marine Network cable is to route through.

2. Using a 1.25" (31.7 mm) paddle drill bit or hole saw, drill the installation hole.

3. Refer to the diagram below for trimming instructions. Carefully trim the cable hole, as needed.

4. Route the cable to the unit.

5. Spread the grommet apart at the split ,and place it around the cable (see below).

6. Firmly push the grommet into the installation hole until it is seated. Apply marine sealant, as needed, to weatherproof the cable.

Trim out to this line for

the Marine Video Cable

Use this hole (no trim) for the Power/Data,

Marine Network, or GPS 17 Cable

Split

GPSMAP 3006C/3010C & GPS 17