Garmin Fusion Apollo MS-ERX400 Kullanıcı El Kitabı - Sayfa 15
Denizcilik Ekipmanları Garmin Fusion Apollo MS-ERX400 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Garmin Fusion Apollo MS-ERX400 20 sayfaları.
Ayrıca Garmin Fusion Apollo MS-ERX400 için: Kurulum Talimatları Kılavuzu (8 sayfalar)
Sayfayı Yazdır
Updating the Remote Control Software Using the Fusion Link App
You must connect the Fusion-Link app to the network using a wireless router or wireless access point to update
the software. You cannot update the software using a Bluetooth connection.
If the Fusion PartyBus network has a wireless router or wireless access point, you can update the remote
control software using the Fusion-Link app, available for compatible Apple
SM
Store
or the Google Play
Do not turn off the device or disconnect the power during a software update. Turning off the power during a
software update may cause the device to become unresponsive.
NOTE:
• The device may restart a few times when updating. This is normal.
• You can program only newer versions of software on the device.
1 Connect your mobile device to a wireless router or wireless access point on the Fusion PartyBus network.
2 Open the Fusion-Link app, and verify that you can see the remote control in the app.
3 If the Fusion PartyBus is not connected to the internet, disconnect the mobile device from the wireless router
or access point.
4 In the Fusion-Link app, select
The app downloads the software update file.
5 If the Fusion PartyBus is not connected to the internet, after the app finishes downloading the update file,
reconnect the mobile device to the wireless router or access point on the Fusion PartyBus network.
6 In the Fusion-Link app, select the name of the remote control.
7 Select
> GENERAL > Software Updates > Online Software Update.
The app transfers the software update to the remote control over the Wi‑Fi
updates the software, and then it restarts.
Troubleshooting
The stereo does not respond to key presses
• Hold
until the stereo turns off, and turn it on again to reset the stereo.
• Disconnect power to the stereo for two minutes to reset the stereo.
Network Troubleshooting
If you cannot see or connect to Fusion PartyBus devices on the network, check the following:
• Verify that only one device, either a stereo or a router, is configured as a DHCP server.
• Verify that all Fusion PartyBus devices, network switches, routers, and wireless access points are connected
to the network and turned on.
• Verify that wireless Fusion PartyBus devices are connected to a wireless router or wireless access point on
the network.
NOTE: Wired connections are more reliable than wireless connections. If possible, you should connect
devices to the network using an Ethernet cable.
• You may experience wireless interference if there are many nearby wireless access points. Change the
channel on your router or wireless access point to test for and correct interference.
• Connecting a Bluetooth device to a stereo configured as a wireless access point or client may reduce
wireless performance. Disconnect Bluetooth devices to test for and correct interference.
• If you configured static IP addresses, verify that every device has a unique IP address, that the first three
sets of numbers in the IP addresses match, and that the subnet masks on every device are identical.
• If you have made configuration changes that might be causing networking issues, reset all network settings
to the factory default values.
More Information
store.
™
> CHECK FOR UPDATES > MS-ERX400 > Download.
®
or Android
NOTICE
™
on the Apple App
network, the remote control
®
11