Garmin GHP 10 Marine Autopilot System Teknik Referans - Sayfa 41

Denizcilik Ekipmanları Garmin GHP 10 Marine Autopilot System için çevrimiçi göz atın veya pdf Teknik Referans indirin. Garmin GHP 10 Marine Autopilot System 42 sayfaları. Tachometer reference
Ayrıca Garmin GHP 10 Marine Autopilot System için: Hızlı Başlangıç Kılavuzu (21 sayfalar), Kurulum Talimatları Kılavuzu (48 sayfalar), Kurulum Talimatları Kılavuzu (26 sayfalar), Uygunluk Beyanı (1 sayfalar), Referans (1 sayfalar)

Configuring the Wind Angle Filter

The wind angle filter governs how quickly the NMEA 2000-compatible display device shows a change in the wind angle. A lower filter setting

shows changes in the wind angle more gradually, and may stabilize the display.

To configure the wind angle filter:

1. While viewing the NMEA 2000 device information, select

2. Choose from the following options to adjust the filter settings.

•

Off—the wind angle data is not filtered.

•

On—select a lower number to update the display device less often, and help the gauge needle or wind angle number to move or change

more steadily.

•

Auto—automatically adjusts the filter settings based on wind conditions.

Configuring the GWS 10 if the Filter and Offset Selections Are Not Displayed

Depending on the version of software loaded on your Garmin marine instrument, the specific configuration options may not be displayed on the

configuration screens.

To configure the wind angle offset if the menu option is not displayed:

1. Select

Generic Configuration

2. Enter the following command: "ANGLEOFFSET="

3. Follow the command with a number between 0 and 359, in degrees (for example: ANGLEOFFSET=180).

To configure the wind angle filter if the menu option is not displayed:

1. Select

Generic Configuration

2. Enter the following command: "ANGLEFILTER="

3. Follow the command with a number between 0 and 254, representing a time constant in increments of 0.25 second, or 255 to represent the

Automatic setting (for example: ANGLEFILTER=12).

To configure the wind speed filter:

1. Select Generic Configuration to specify data for the filter and offset settings.

2. Enter the following command: "SPEEDFILTER="

3. Follow the command with a number between 0 and 254, representing a time constant in increments of 0.25 second, or 255 to represent the

Automatic setting (for example: SPEEDFILTER=215).

Technical Reference for Garmin NMEA 2000 Products

Config

to specify data for the filter and offset settings.

Wind Angle

Filter.

NMEA 2000 Checklist