Garmin Gladiator TR-1 Kullanıcı El Kitabı - Sayfa 7
Denizcilik Ekipmanları Garmin Gladiator TR-1 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Garmin Gladiator TR-1 36 sayfaları. Garmin tr-1 marine autopilot: user guide
Ayrıca Garmin Gladiator TR-1 için: Kurulum ve Kullanım Kılavuzu (4 sayfalar), Kullanıcı El Kitabı (13 sayfalar)
Sayfayı Yazdır
Turn power on by pressing and releasing the [Deckmount] switch. Turn the power off by pressing and holding
the switch down until the [Deckmount] switch light has extinguished (about three seconds).
Power on is indicated by illumination of the [Deckmount] switch button and one or more
LED's lit on the Hand Held.
Both the [Deckmount] button light and remote [STBY] LED will blink for about 30 seconds
after turning power on. During this 30-second time, the pilot computers are running self
test and starting up the compass and gyroscope. Autopilot steering is not available during this start up period.
While the system is in standby mode, the STBY LED will light solid on and the deckmount light will briefl y
turn off once a second (occulting at 1 Hz).
To illuminate keypad on the remote for nighttime operation:
brightness of the orange LED's between bright and dim when the setup is held down.
The [Auto/Stby] button engages and disengages autopilot steering. The
[Deckmount] button performs the same function after the pilot is powered up.
When the button is pressed and released to go into Auto mode, the pilot captures the compass heading and
subsequently moves the rudder to hold that heading. The LED next to "Auto" will illuminate and the deckmount
light will be lit solid on. You should be steering your boat on a constant heading at the time you press the [Auto/
Stby] button.
The rudder (steering) is directly controlled by [Right Arrow] and [Left Arrow] buttons
when the Rudder LED is illuminated. When you program the [Plus (+)] button for
Rudder, the system will toggle between Rudder mode and heading hold mode when you
press and release the [Plus (+)] button. (Autopilot or heading hold are not available
while you are in Rudder function.)
Power On/Off (Deckmount Switch)
Illuminate Keypad on Remote
Press and hold [Setup] and press and release the [Up Arrow].
Repeat to turn the back light off. The down arrow will toggle the
Engaging the Autopilot In Heading Hold
Change Heading with Rudder Function
7