Garmin GMR 18 HD3 Kurulum Talimatları Kılavuzu - Sayfa 7

Denizcilik Ekipmanları Garmin GMR 18 HD3 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Garmin GMR 18 HD3 15 sayfaları.

Mounting the Radar

Before you mount the radar, you must review the mounting location considerations and select a mounting

location.

NOTE: The supplied M8 x 1.25 x 60 threaded rods can be used on mounting thicknesses of 5 to 30 mm (

in.) (recommended). For surfaces over 30 mm (1

1 If you are not installing the device on a pre-drilled Garmin compatible radar mount, use the included

mounting template to drill four 9.5 mm (

2 Connect the power cable to the power port

3 Press the cables into any of the guide grooves

hold-down plate

The cables should be bent or twisted as little as possible.

4 Using the arrow on the bottom as a reference, position the radome on the mounting surface aligned to the

front of the vessel.

NOTE: If you choose not to align the dome with the front of the vessel, you can adjust the front-of-boat offset

after the dome is installed

5 Apply the included anti-seize compound to the threads of the four M8 x 1.25 x 60 threaded rods.

6 Insert the four threaded rods into the mounting holes on the bottom of the radome.

Up to 50 mm (2 in.) of the threaded rods may extend below the radome.

7 Apply a bead of marine sealant on the mounting surface around each mounting hole.

in.) mounting holes.

and the network cable to the network port

on the bottom of the case, and secure them using a cable

(Measuring and Setting the Front-of-Boat Offset,

in.), use longer threaded rods.

page 9).