AEG FAV55VI3P Kullanıcı Kılavuzu - Sayfa 25

Bulaşık Makinesi AEG FAV55VI3P için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG FAV55VI3P 32 sayfaları.

AEG FAV55VI3P Kullanıcı Kılavuzu
Problem and alarm code
The level of water inside the
appliance is too high.
The display shows iF1.
The appliance stops and
starts more times during op‐
eration.
The programme lasts too
long.
The displayed programme
duration is different than the
duration in the consumption
values table.
The remaining time in the
display increases and skips
nearly to the end of the pro‐
gramme duration.
Small leak from the appli‐
ance door.
The appliance door is diffi‐
cult to close.
The appliance door opens
during the wash cycle.
Rattling or knocking sounds
from the inside of the appli‐
ance.
The appliance trips the cir‐
cuit-beaker.
The appliance is switched
on but does not operate.
The display shows PF.
The appliance switches off
during operation.
Possible cause and solution
Switch the appliance off and on.
Make sure that the filters are clean.
Make sure that the outlet hose is installed at the right
height above the floor. Refer to the installation instruc‐
tions.
It is normal. It provides optimal cleaning results and en‐
ergy savings.
If the delay start option is set, cancel the delay setting or
wait for the end of the countdown.
Activating options increases the programme duration.
Refer to the consumption values table in the chapter
"Programme selection".
This is not a defect. The appliance is working correctly.
The appliance is not levelled. Loosen or tighten the ad‐
justable feet (if applicable).
The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
The appliance is not levelled. Loosen or tighten the ad‐
justable feet (if applicable).
Parts of the tableware are protruding from the baskets.
The AirDry function is activated. You can deactivate the
function. Refer to "Basic settings".
The tableware is not properly arranged in the baskets.
Refer to basket loading leaflet.
Make sure that the spray arms can rotate freely.
The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and
the capacity of the meter or turn off one of the applian‐
ces in use.
Internal electrical fault of the appliance. Contact an Au‐
thorised Service Centre.
Power supply is out of the operating range. The wash
cycle is temporarily interrupted and resumes automati‐
cally once the power is restored.
Complete power outage. The wash cycle is temporarily
interrupted and resumes automatically once the power
is restored.
ENGLISH
25