TIp: The angles are configured clockwise around the mast of the boat. For example,
90 degrees is on the starboard side of the boat, and 270 degrees is on the port side.
Configuring the Wind Speed Filter
The wind speed filter governs how quickly the NMEA 2000-compatible display device
shows a change in the wind speed. A lower filter setting shows changes in the wind speed
more gradually, and may stabilize the display.
To configure the wind speed filter:
1.
While viewing the NMEA 2000 device information, select Config > Wind Speed
2. Choose from the following options to adjust the filter settings.
•
Off—the wind speed data is not filtered.
•
On—select a lower number to show a change in the wind speed more gradually, and
help the gauge needle or wind speed number to move or change more steadily.
•
Auto—automatically adjusts the filter settings based on wind conditions.
Configuring the Wind Angle Filter
The wind angle filter governs how quickly the NMEA 2000-compatible display device
shows a change in the wind angle. A lower filter setting shows changes in the wind angle
more gradually, and may stabilize the display.
To configure the wind angle filter:
1.
While viewing the NMEA 2000 device information, select Config > Wind Angle
2. Choose from the following options to adjust the filter settings.
•
Off—the wind angle data is not filtered.
•
On—select a lower number to update the display device less often, and help the
gauge needle or wind angle number to move or change more steadily.
•
Auto—automatically adjusts the filter settings based on wind conditions.
Configuring the GWS 10 if the Filter and Offset
Filter.
Selections Are Not Displayed
Depending on the version of software loaded on your Garmin marine instrument, the
specific configuration options may not be displayed on the configuration screens.
To configure the wind angle offset if the menu option is not displayed:
1.
Select Generic Configuration
2. Enter the following command: "ANGLEOFFSET="
3. Follow the command with a number between 0 and 359, in degrees (for example:
ANGLEOFFSET=180).
To configure the wind angle filter if the menu option is not displayed:
1.
Select Generic Configuration
2. Enter the following command: "ANGLEFILTER="
3. Follow the command with a number between 0 and 254, representing a time constant
in increments of 0.25 second, or 255 to represent the Automatic setting (for example:
ANGLEFILTER=12).
to specify data for the filter and offset settings.
to specify data for the filter and offset settings.
Filter.
Sayfayı Yazdır