Garmin Reactor 40 Kicker Kurulum Talimatları Kılavuzu - Sayfa 15
Denizcilik Ekipmanları Garmin Reactor 40 Kicker için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Garmin Reactor 40 Kicker 29 sayfaları.
Ayrıca Garmin Reactor 40 Kicker için: Yapılandırma Kılavuzu (6 sayfalar), Yapılandırma Kılavuzu (8 sayfalar)
Sayfayı Yazdır
Installing the Flat Bracket and Linkage Arm
You should use the flat bracket when installing the steering actuator on kicker motors with bolts or mounting
holes on the underside of the tiller arm, such as Yamaha motors.
1 Locate the mounting holes or bolts on the underside of the tiller arm on the kicker motor that align with the
holes on the bracket.
2 Complete an action:
• If your motor has bolts in the holes, remove and retain the bolts.
• If your motor does not have bolts in the holes, purchase the appropriate bolts for the holes.
3 Using the existing bolts or purchased bolts, secure the bracket
NOTE: If there is adequate clearance beneath the motor for you to tighten the bolts after the linkage is
assembled, you may find it easier to secure the bracket to the kicker motor tiller arm after you have
assembled the linkage.
4 Place the black nylon washer
5 With the wrench flats
threaded rod on the bracket.
7
6 Using an 11 mm (
/
16
7 Place a nylon washer
8 With the notched end of the linkage arm facing away from the bracket, place the linkage arm
bushing on the bracket.
9 Place the other nylon washer
10 With the narrow end of the nut
rod.
19
11 Using a 15 mm (
/
32
over the threaded rod on the bracket.
on the bushing
pointing away from the bracket, screw the bushing onto the
in.) wrench, tighten the bushing onto the bracket.
over the bushing on the bracket.
over the bushing on the bracket.
facing towards the bracket, screw the nut
in.) wrench, tighten the nut to secure the linkage arm to the bracket.
to the underside of the tiller arm.
onto the end of the threaded
over the
15