AEG FAVORIT 44080 I Kullanıcı Bilgileri - Sayfa 38

Bulaşık Makinesi AEG FAVORIT 44080 I için çevrimiçi göz atın veya pdf Kullanıcı Bilgileri indirin. AEG FAVORIT 44080 I 48 sayfaları. Electrolux user instructions dishwasher favorit 44080 i
Ayrıca AEG FAVORIT 44080 I için: Kullanıcı Bilgileri (40 sayfalar), Kullanıcı Kılavuzu (40 sayfalar)

Sayfayı Yazdır

Connecting the dishwasher

Connecting to the water supply

• The dishwasher can be connected to cold and hot water supplies up

to max. 60°C.

• The dishwasher must not be connected to open hot water appliances

or instantaneous water heaters.

Permitted water pressure

Lowest permitted water pressure:

1 bar (=10 N/cm2 =100 kPa)

Highest permitted water pressure:

10 bar (=100 N/cm2 =1 MPa)

Connecting the inlet hose

The water inlet hose must not be kinked, crushed or entangled when it

is being connected.

Connect the threaded hose fitting (ISO 228-1:2000) on the water inlet

hose to a tap with an external thread (¾ inch). The inlet hose is fitted

with either a plastic or a metal nut:

– Only tighten the nut hand tight.

Then do a visual check for water tightness. (Make sure that the tap is

not dripping.)

So that access to the tap in the kitchen is not restricted by the use of

the dishwasher, we recommend installing an additional tap, or fitting a

T-branch to the existing tap.

If you need a longer water inlet hose than that supplied, the following

VDE-approved complete hose sets are to be used. These are available

from your local dealer.

– Hose kit "WRflex 100" (Code: 911 239 034)

– Hose kit "WRflex 200" (Code: 911 239 035)

Consult your plumber if the water pres-

sure is less than 1 bar.

If the water pressure is greater than 10

bar, a pressure reduction valve must be

used (available from your dealer).