AEG FAVORIT 44080 I Kullanıcı Kılavuzu - Sayfa 19

Bulaşık Makinesi AEG FAVORIT 44080 I için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG FAVORIT 44080 I 40 sayfaları. Electrolux user instructions dishwasher favorit 44080 i
Ayrıca AEG FAVORIT 44080 I için: Kullanıcı Bilgileri (48 sayfalar), Kullanıcı Bilgileri (40 sayfalar)

Sayfayı Yazdır

Using 3in1 detergents

These products are detergents with a combined cleaning, rinsing and salt func

tion.

When the 3in1 function is activated,

– the addition of special salt and rinse aid from the respective dispenser is pre

vented.

– If the salt and rinse aid dispensers are empty, this is not indicated.

– The dishwashing cycles can be up to 30 minutes longer.

If you want to use 3in1 detergents, check whether these detergents are suitable

for your water hardness. (Follow manufacturer's instructions!)

If your water hardness is higher than that recommended by the manufacturer

but you would nevertheless like to use 3in1 detergent, proceed as follows:

• With the 3in1 function selected, set the water softener one hardness setting

lower than when rinsing without 3in1 detergent.

• Fill up the dispenser (if this is empty) with special salt.

The dishwasher remembers the two different settings of the degree of hardness

for rinsing with and without 3in1 function.

If you want to use 3in1 products

1. Press the ON/OFF button.

2. Press the 3 IN 1 button.

The button indicator lights up: 3in1 function is selected.

Before the start of the dishwashing cycle put 3in1 detergent in the detergent

dispenser.

As the rinse aid inflow is automatically switched off when the 3in1 function is

activated, it may come about because of the different quality standards in the

3in1 detergent, that the dishes do not dry sufficiently.

If this happens, proceed as follows (see section "Adding rinse aid"):

• Fill up the dispenser (if this is empty) with rinse aid.

• Set rinse aid dosage to "2" mechanically.

• Activate rinse aid inflow.

If you do not want to use 3in1 products any more

If you want to stop using 3in1 products, please do the following:

• Deactivate the 3in1 function.

• Fill up the dispensers for salt and rinse aid again.

• Switch the water softener to the highest setting and perform up to three nor

mal cycles without loading any dishes.

• Then set the water softener to the water hardness in your area.

In daily use