Garmin VHF 215 AIS Series Kullanıcı El Kitabı - Sayfa 28
Deniz Telsizi Garmin VHF 215 AIS Series için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Garmin VHF 215 AIS Series 37 sayfaları.
Ayrıca Garmin VHF 215 AIS Series için: Kurulum Talimatları Kılavuzu (4 sayfalar), Kurulum Talimatları Kılavuzu (15 sayfalar)
Sayfayı Yazdır
identify and locate vessels by electronically exchanging data with other nearby
vessels and AIS base stations. When used with a compatible chartplotter or
multifunction display (MFD), AIS can assist with collision avoidance.
NOTE:
AIS is not available on all models.
Turning On and
Off
AIS
1
Select
MENU
>
AIS.
2
Select
ON
or
OFF.
3
SelectOK.
Automatic
Transmitter
Identification
System
Automatic Transmitter Identification System (ATIS) is a vessel identification
system used on certain inland waterways in some European countries. See your
Garmin dealer to program your VHF radio if you plan to use your radio on
waterways that are within the bounds of the Regional Arrangement Concerning
the Radiotelephone Service on Inland Waterways (the Basel Agreement). ATIS is
prohibited outside the European inland waterways that are covered by the Basel
Agreement.
When you enable ATIS, your radio sends a data signal identifying your station at
the end of every transmission. Data identifying your position is not sent, but your
position is calculated through the method of triangulation by coastal stations that
receive your transmissions.
To enable ATIS, you must enter your
ATIS
identification number (page 6), and
tum on A TIS. See your Garmin dealer to determine your ATIS identification
number and to learn about
ATIS
requirements for your region.
Your radio disables these functions when you enable ATIS.
•
Digital Selective Calling (DSC)
•
Monitor two or three channels (Dual watch and Tri watch)
•
Scanning channels
International channels 6, 8, 10, 11, 12, 13, 14, 71, 72, 74, and 77 restrict
transmitting to low-power (1 W) when you enable
ATIS.
6
Entering Your ATIS Identification Number
NOTICE
You can enter your ATIS identification number only once. If you must change
your ATIS identification number after enteri~ it, you must take your radio to your
Garmin dealer for reprogramming.
NOTE:
You can access the ATIS settings on the radio after the ATIS feature is
activated by your Garmin dealer.
1
Select
MENU
>
ATIS
>
MY ATIS ID.
2
Tum
SELECT
clockwise or counter-clockwise to increase or decrease the
number.
3
Press
SELECT
to accept the number.
4
Repeat these steps for each digit.
5
Select
ACCEPT.
The radio prompts you to reenter your number.
6
Enter your ATIS number again, and select
ACCEPT.
If the A TIS numbers do not match, a message appears.
7
If necessary, select
RETRY,
and enter the number again.
Turning On and Off ATIS
1
Select
MENU
>
ATIS
>
ATIS.
2
Select
ON
or
OFF.
11!111
appears on the screen when ATIS is enabled.
3
Select
OK.
QuiCK ~tart
Manual