AEG FSS62700P Kullanıcı Kılavuzu - Sayfa 20

Bulaşık Makinesi AEG FSS62700P için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG FSS62700P 24 sayfaları.

Sayfayı Yazdır

www.aeg.com

Problem and alarm code

The appliance does not fill

with water.

The display shows

The appliance does not

drain the water.

The display shows

The anti-flood device is on.

The display shows

The appliance stops and

starts more times during op-

eration.

The program lasts too long.

The remaining time in the

display increases and skips

nearly to the end of program

time.

Small leak from the appli-

ance door.

The appliance door is diffi-

cult to close.

Rattling/knocking sounds

from inside the appliance.

The appliance trips the cir-

cuit-beaker.

Possible cause and solution

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not

too low. For this information, contact your local water

authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter in the inlet hose is not clogged.

• Make sure that the inlet hose has no kinks or bends.

• Make sure that the sink spigot is not clogged.

• Make sure that the filter in the outlet hose is not clog-

ged.

• Make sure that the interior filter system is not clogged.

• Make sure that the drain hose has no kinks or bends.

• Close the water tap and contact an Authorised Service

Centre.

• It is normal. It provides optimal cleaning results and en-

ergy savings.

• Select the TimeSaver option to shorten the program

time.

• If the delayed start option is set, cancel the delay setting

or wait for the end of the countdown.

• This is not a defect. The appliance is working correctly.

• The appliance is not levelled. Loosen or tighten the ad-

justable feet (if applicable).

• The appliance door is not centred on the tub. Adjust the

rear foot (if applicable).

• The appliance is not levelled. Loosen or tighten the ad-

justable feet (if applicable).

• Parts of the tableware are protruding from the baskets.

• The tableware is not properly arranged in the baskets.

Refer to basket loading leaflet.

• Make sure that the spray arms can rotate freely.

• The amperage is insufficient to supply simultaneously all

the appliances in use. Check the socket amperage and

the capacity of the meter or turn off one of the applian-

ces in use.

• Internal electrical fault of the appliance. Contact an Au-

thorised Service Centre.