AEG OKO FAVORIT 40660 i Kullanıcı Talimatları - Sayfa 11

Bulaşık Makinesi AEG OKO FAVORIT 40660 i için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. AEG OKO FAVORIT 40660 i 48 sayfaları. Aeg dishwasher
Ayrıca AEG OKO FAVORIT 40660 i için: Kullanıcı Bilgileri (44 sayfalar), Kullanıcı Talimatları (40 sayfalar), Kullanıcı Talimatları (44 sayfalar), Kullanıcı Talimatları (44 sayfalar)

Adjust the water softener to the setting given in the table that corre-

sponds to the hardness of the water in the area where you live.

It is only possible to adjust the water hardness setting when there is no

programme running. If you have inadvertently started a programme

(an LED indicator is constantly illuminated), then the programme must

be cancelled by pressing the appropriate button.

1. The dishwasher must be switched off.

2. Manual setting:

Open the door on the dishwasher.

3. Remove the lower basket from the

dishwasher.

4. Turn the water hardness switch to 0

or 1.

5. Re-position the lower basket.

6. Electronic setting:

Press the water-softener and func-

tion buttons simultaneously and keep

them pressed.

7. In addition press the ON/OFF button.

8. The LED indicator for the water-softener button flashes.

9. Press the water-softener button again.

– The LED indicator for the water-softener button will be illuminated

continuously for an initial 5 seconds and then begin to flash.

– The number of flashes corresponds to the hardness setting.

– The sequence of flashes is repeated several times after a 5 second

pause.

10. Each time you press the water-softener button the hardness setting

will go up by 1.

(Exception: Hardness setting 1 follows hardness setting 5).

– If the hardness setting is changed, the LED indicator for the water-

softener button will confirm the change by remaining illuminated

continuously for 5 seconds and then flashing again.

– The number of flashes corresponds to the new hardness setting.

– The sequence of flashes is repeated several times after a 5 second

pause.

11. Once the hardness setting is correct, press the ON/OFF switch.

The hardness setting is then saved.

Operating Instructions