AEG SatelliteClean 6000 FSB64907Z Kullanıcı Kılavuzu - Sayfa 25
Bulaşık Makinesi AEG SatelliteClean 6000 FSB64907Z için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG SatelliteClean 6000 FSB64907Z 32 sayfaları.
Sayfayı Yazdır
Problem and alarm code
The displayed programme
duration is different than the
duration in the consumption
values table.
The remaining time in the
display increases and skips
nearly to the end of the pro‐
gramme duration.
Small leak from the appli‐
ance door.
The appliance door is diffi‐
cult to close.
The appliance door opens
during the wash cycle.
Rattling or knocking sounds
from the inside of the appli‐
ance.
The appliance trips the cir‐
cuit-beaker.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
WARNING!
We do not recommend using
the appliance until the
problem has been
completely fixed. Unplug the
appliance and do not plug it
in again until you are certain
that it operates correctly.
Possible cause and solution
•
Refer to the consumption values table in the chapter
"Programme selection".
•
This is not a defect. The appliance is working correctly.
•
The appliance is not levelled. Loosen or tighten the ad‐
justable feet (if applicable).
•
The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
•
The appliance is not levelled. Loosen or tighten the ad‐
justable feet (if applicable).
•
Parts of the tableware are protruding from the baskets.
•
The AirDry function is activated. You can deactivate the
function. Refer to "Basic settings".
•
The tableware is not properly arranged in the baskets.
Refer to basket loading leaflet.
•
Make sure that the spray arms can rotate freely.
•
The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and
the capacity of the meter or turn off one of the applian‐
ces in use.
•
Internal electrical fault of the appliance. Contact an Au‐
thorised Service Centre.
12.1 The product number
code (PNC)
If you contact an Authorised Service
Centre, you need to provide the product
number code of your appliance.
The PNC can be found on the rating
plate on the appliance door. You can
also check the PNC on the control panel.
Before checking the PNC, make sure the
appliance is in the programme selection.
1. Press and hold simultaneously
and
The display shows the PNC of your
appliance.
2. To exit the PNC presentation, press
and hold simultaneously
for about 3 seconds.
ENGLISH
for about 3 seconds.
and
25