Brother MFC-T910DW Referans Kılavuzu - Sayfa 21

Hepsi Bir Arada Yazıcı Brother MFC-T910DW için çevrimiçi göz atın veya pdf Referans Kılavuzu indirin. Brother MFC-T910DW 29 sayfaları. Brief explanations for routine operations
Ayrıca Brother MFC-T910DW için: Ürün Güvenlik Kılavuzu (24 sayfalar), Hızlı Kurulum Kılavuzu (2 sayfalar), Referans Kılavuzu (30 sayfalar)

Sayfayı Yazdır

Error and Maintenance Messages

The most common error and maintenance messages are shown in the table. For more detailed

information, see the Online User's Guide.

You can correct most errors and perform routine maintenance yourself. If you need more tips, go

to your model's FAQs & Troubleshooting page on the Brother Solutions Center at

support.brother.com.

Error Message

Absorber NearFull The ink absorber box must be replaced soon. Call Brother Customer

B&W Print Only

Cover is Open.

Data Remaining

Disconnected

Document Jam

DR Mode in Use

Action

Service or a Brother Authorized Service Center to have your machine

serviced.

• The ink absorber box absorbs the small amount of ink emitted

during print head cleaning.

The amount of remaining ink in one or more of the ink tanks (except

black) is low.

Refill the ink tank.

For more detailed information, see the Online User's Guide: Refill the

Ink Tanks.

The machine may stop all print operations and you may not be able to

use the machine until you refill the ink tank in the following cases:

• If you unplug the machine.

• If you select the Slow Drying Paper option on the machine or in

the printer driver.

The ink tank cover is not locked in the closed position.

Firmly close the ink tank cover until it locks into place.

Press Detener/Salir (Stop/Exit). The machine will cancel the job and

clear it from the memory. Try to print again.

Try to send or receive again.

If calls are stopped repeatedly and you are using a VoIP (Voice over

IP) system, try changing the Compatibility to Basic (for VoIP).

See Related Information: Telephone Line Interference/VoIP at the end

of this section.

The document was not inserted or fed correctly, or the document

scanned from the ADF was too long.

For more detailed information, see the Online User's Guide: Document

Jams.

The machine is in Distinctive Ring mode. You cannot change the

Receive Mode from Manual to another mode.

Set Distinctive Ring to Off.

For more detailed information, see the Online User's Guide: Turn off

Distinctive Ring.