Brother DCP-585CW Hızlı Kurulum Kılavuzu - Sayfa 28
Yazıcı Brother DCP-585CW için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Brother DCP-585CW 45 sayfaları. Quick setup guide - spanish
Ayrıca Brother DCP-585CW için: Broşür ve Teknik Özellikler (2 sayfalar), Hızlı Kurulum Kılavuzu (29 sayfalar), (İngilizce) Hızlı Yapılandırma Kılavuzu (43 sayfalar)
Sayfayı Yazdır
For Wireless Network Users
Connecting the Brother machine to the wireless network
13
Configure the wireless
settings (Typical
Wireless Setup in
infrastructure mode)
a
On your machine, press Menu.
Press a or b to choose Network and press
OK.
Press a or b to choose WLAN and press OK.
Press a or b to choose Setup Wizard and
press OK.
When Network I/F switched to
Wireless is displayed, press OK to accept.
This will start the wireless setup wizard.
To cancel, press Clear/Back.
b
The machine will search for available SSIDs. If
a list of SSIDs is displayed, use the a or b keys
to choose the SSID you wrote down in step 12
on page 27, then press OK. Go to f.
Note
It will take several seconds to display a list of
available SSIDs.
If your access point is set to not broadcast the
SSID you will have to manually add the SSID
name. Go to c.
c
Press a or b to choose <New SSID> and press
OK. Go to d.
d
Enter the SSID you wrote down in step 12 on
page 27 using the a, b keys to choose each
letter or number.
You can use the d and c keys to move the
cursor left and right. For example, to enter the
letter a, press the a key once. To enter the
number 3, hold down the a key until it appears.
The letters appear in this order: lower case,
upper case, numbers and then special letters.
(For more information, see Entering Text for
Wireless Settings on page 43.)
Press OK when you have entered all the
characters.
e
Press a or b to choose Infrastructure,
then press OK.
28
f
Use the a, b and OK keys to choose one of the
options below: If your network is configured for
Authentication and Encryption you must match
the settings used for your network.
No Authentication or Encryption:
Choose Open System, press OK then
choose None for Encryption Type? and
press OK. Then press
settings. Go to i.
No Authentication with WEP Encryption:
Choose Open System, press OK then use
the a or b to choose WEP for the
Encryption Type? and press OK.
Go to g.
Authentication with WEP Encryption:
Choose Shared Key and press OK.
Go to g.
Authentication with WPA/WPA2-PSK
(TKIP or AES) Encryption:
Choose WPA/WPA2-PSK and press OK.
Go to h.
g
Press a or b to choose the appropriate key
number and press OK. Enter the WEP key you
wrote down in step 12 on page 27 using the a,
b keys to choose each letter or number.
You can use the d and c keys to move the
cursor left and right. For example, to enter the
letter a, press the a key once. To enter the
number 3, hold down the a key until it appears.
The letters appear in this order: lower case,
upper case, numbers and then special letters.
(For more information, see Entering Text for
Wireless Settings on page 43.)
Press OK when you have entered all the
characters, then press
settings. Go to i.
Yes to apply your
Yes to apply your