DCP-J572DW / MFC-J491DW / MFC-J497DW
Quick Setup Guide
Read the Product Safety Guide first, then read this Quick Setup Guide
for the correct installation procedure.
Unpack the machine and check the components
1
The components included in the box may differ depending on your country.
Remove the protective tape and film covering the machine.
Inbox Ink Cartridges*
• Black
• Yellow
• Cyan
• Magenta
*Ink cartridges contain
approximately the same page
yield as replacement cartridges
Watch our FAQ videos for help
(Standard).
with setting up your Brother
machine.
support.brother.com/videos
2
Load paper in the paper tray
3
Connect the power cord
(Example for UK)
NOTE
You can adjust the control panel angle to read the
LCD more easily.
6
Install the inbox ink cartridges
Open the ink cartridge cover, and then
remove the orange protective part
from the machine.
NOTE
Do not throw away the orange protective part.
You will need it if you transport the machine.
Select your language
8
(if needed and only for
certain models)
1.
Press Settings.
2.
Press a or b to select the following:
a. Select [Initial Setup], and then press OK.
b. Select [Local Language], and then press OK.
c. Select your language, and then press OK.
3.
Press Stop/Exit.
Quick Setup Guide
Product Safety Guide
Brother Installation Disc
Open the output paper tray
cover a.
Fan the paper well and load it in the tray.
Select your country
4
or language
(Initial setup only)
After turning the machine on, you may need to set your
country or language (depending on your machine).
If required, follow the on-screen instructions.
Follow the steps on the LCD
to unpack and install the ink
cartridges.
The machine will prepare the ink
tube system for printing.
Connect the telephone line cord (MFC models only)
9
If you are not using your machine as a fax, go to
For more information on using the fax feature, see the Online User's Guide.
The latest manuals are available at the Brother Solutions Center:
support.brother.com/manuals
Power Cord
(for UK)
(for others)
Telephone Line Cord
(MFC models only)
Close the output paper tray cover, and
Adjust the paper guides.
then slowly push the tray completely
into the machine.
Quickly shake just the black
ink cartridge horizontally
15 times as shown, before
inserting it into the machine.
10
.
NOTE
• Most of the illustrations in this Quick Setup Guide show the
MFC-J491DW.
• Save all packing materials and the box in case you must ship your
machine.
• You must purchase the correct interface cable for the
interface you want to use.
USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more
than 2 metres long.
Secure Network Access
Your machine's default password is on the label on
the back of the machine (preceded by "Pwd").
We strongly recommend you change it to protect your
machine from unauthorised access.
NOTE
Pull out the paper support a, and unfold
the paper support flap b so that the
printed pages do not fall.
5
Set the date and time
Follow the prompts displayed on the LCD to set the
date and time.
7
Machine settings
When the machine has finished the initial cleaning
process, follow the steps on the LCD to configure
the machine's settings.
• Check print quality
• Set Firmware Update defaults
• Print the installation sheet
D0141W001-01
UK
Version C
Sayfayı Yazdır