Brother GTX Series Referans Kılavuzu - Sayfa 9
Yazıcı Brother GTX Series için çevrimiçi göz atın veya pdf Referans Kılavuzu indirin. Brother GTX Series 13 sayfaları.
Ayrıca Brother GTX Series için: Referans Kılavuzu (13 sayfalar)
Sayfayı Yazdır
MAINTENANCE PARTS CLEANING & REPLACING PROCEDURES
WARNING
W
E
1
Simply remove the old Wiper Cleaner by lifting it up. Replace with a new one.
!
> After removing and replacing of the Flushing Foams, do NOT forget to clean the side holes of the receivers!
It is very critical to avoid clogging of the ink path to the waste tank!
> Always use this menu to perform cleanings or to replace parts
Menu
Maintenance
>
ERROR
In case of Warning/Error messages please follow the below procedures
MESH
FINE
Maintenance Part Clean/Replace
>
MAINTENANCE PARTS EXCHANGE
WIPER CLEANER REPLACEMENT
2
FLUSHING FOAM REPLACEMENT
Lift up the Flushing Receivers and
place them on cleaning paper to
avoid dripping ink.
Remove Flushing Foams and clean
the holes of the 2 grey receivers.
Install new Foams and put back the
receivers at their original location.
Clean also under the receivers place!
FAN FILTER REPLACEMENT
Extract the 2 filter holders from
the back of the machine.
Mount a new Fan Filter in each
black frames.
Coarse mesh surface in direction
of the inner side of the printer
and fine mesh surface in direction
of the outside of the printer.
COARSE
>
MENU
MENU
OK
OK
3
and follow instructions on the display
9