AEG 7000 ProSteam Kullanıcı Kılavuzu - Sayfa 19
Yıkayıcı AEG 7000 ProSteam için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG 7000 ProSteam 48 sayfaları.
Ayrıca AEG 7000 ProSteam için: Kullanıcı Kılavuzu (48 sayfalar)
![AEG 7000 ProSteam Kullanıcı Kılavuzu](/uploads/products/server2/241365/241365.jpg)
dashes to indicate that no programme
was selected.
6.4 Temp.
When you select a washing programme,
the appliance automatically proposes a
default temperature.
The indicator Cold = cold water.
The indicator of the set temperature
comes on.
6.5 Spin
When you set a programme, the
appliance automatically sets the
maximum spin speed allowed, except in
Denim programme.
By means of this button, you can
change the default spin speed or set
on of the additional spin options:
• Rinse Hold
. The related indicator
comes on.
The final spin is not performed. The
water of the last rinse is not drained
out to prevent the fabrics from
creasing. The washing programme
ends with water in the drum.
The door stays locked and the drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
If you touch the Start/Pause
button, the appliance performs the
spinning phase and drains the water.
• No spin
. The related indicator
comes on.
Set this option to deactivate all spin
phases. The appliance performs only
the draining phase of the selected
washing programme. Set this option
for very delicate fabrics. The rinse
phase uses more water for some
washing programmes
• Quiet
. The related indicator
comes on.
The intermediate and the final
spinning phases are suppressed and
the programme ends with water in the
drum. This helps to reduce creasing.
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are available.
In some programmes the rinses are
performed with more water.
If you touch the Start/Pause
button, the appliance performs only
the draining phase.
The appliance empties the
water out automatically after
approximately 18 hours.
6.6 Prewash
With this option you can add a prewash
phase to a washing programme.
The corresponding indicator above the
touch button illuminates.
• Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust, mud and other
solid particles.
The options can increase the
programme duration.
6.7 Permanent Anti-stain
This option adds an anti-stain phase to
the programme. Use this option for
laundry with hard stains to remove.
To activate/deactivate this option, hold
the Prewash button pressed for 3
seconds until the indicator
goes off on the display.
Pour the stain remover into compartment
.
This option increases the
programme duration.
This option is not available
with a temperature lower
than 40 °C.
ENGLISH
19
comes on/