AEG EWF8024P5WB Kullanıcı Kılavuzu - Sayfa 19

Yıkayıcı AEG EWF8024P5WB için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG EWF8024P5WB 40 sayfaları.

Sayfayı Yazdır

5.4 Starting A Cycle (

To start a program, press the Start/Pause

touchpad. The corresponding pilot light

will stop flashing and a default program

duration will be displayed on the screen.

After approx. 15 minutes from the start of

a program:

The appliance will automatically adjust

the selected program duration

according to the type and size of the

load.

The display will show adjusted

program duration.

NOTE

If you press any touchpad while a

program is operating, the symbol "

will flash on display along with buzzer

sound. (except Start/Pause touchpad

and On/Off button)

5.5 Interruption Of A Program

To pause, press Start/ Pause.

The indicator will start flashing.

Press the Start/Pause again.

The program will continue.

5.6 Changing A Program

Changing a running program is possible

only by switching off the appliance.

Press the "On/Off" button to cancel

the program and to turn off the

appliance.

Press the "On/Off" button again to

start the appliance.

Now you can set a new wash program

and change any available options. Press

Start/Pause to start the new program.

NOTE

The appliance will not drain the water

(except programs; Vapour Refresh, Spin,

Rinse + Spin, Tub Clean).

)

5.7 Changing The Options

It may be possible to change some of the

options after a wash program has started.

Press the touchpad Start/Pause. The

indicator will start flashing.

If available change the options that

you wish.

Press Start/Pause again. The program

will continue.

5.8 Opening The Door

While a program or the Delay End is

operating, the appliance door is locked

and the display shows the indicator "

First, set the machine to PAUSE by

pressing the "Start/Pause" touchpad. Wait

until the door lock indicator goes off, then

the door can be opened.

If the door lock indicator "

disappear, this means that the machine

is already heating and the water level is

above the bottom edge of the door or the

drum is turning. In this case the door

CAN NOT be opened. If you need to

open it, you must drain the water to open

the door.

In case of emergency please

refer to "Emergency door

opening" on page 32.

5.9 At The End Of The Program

The appliance stops automatically.

The acoustic signal will operate.

The display will show "

The indicator of the touchpad

Start/Pause goes off.

The door lock indicator "

Remove the laundry from the

appliance. Make sure that the drum is

empty.

Keep the door partly open, to prevent

the mildew and odours.

Turn off the water tap.

ENGLISH

" does not

" goes off.