AEG KO-LAVAMAT 88840 Kullanıcı Kılavuzu - Sayfa 36
Yıkayıcı AEG KO-LAVAMAT 88840 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG KO-LAVAMAT 88840 48 sayfaları. Aeg prosteam condenser dryer user manual
Sayfayı Yazdır
36
SETTINGS
WATER HARDNESS
Water contains, a variable quantity of limestone and mineral salts of which quantities vary
according to geographical locations thus varying its conductivity values.
Relevant variations of the conductivity of the water compared to those prefixed by the
factory could slightly influence the residual humidity of the laundry at the end of the cycle.
Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity
values of the water.
1. Press OPTION button until WATER HARDNESS selected.
2. Press OK to confirm - frame around bar indicator starts blinking.
3. Press OPTION until you set right hardness level.
4. Press OK to confirm.
available selections:
–
- low conductivity <300 μS/cm
–
- medium conductivity 300-600 μS/cm
–
- high conductivity >600 μS/cm
is set as default.
FULL TANK WARNING - ON/OFF
The container indicator at the end of the programme can be deactivated, for example, if
an external condensed water drain is installed.
1. Press OPTION button until FULL TANK WARNING selected.
2. Press OK to confirm - frame around bar indicator starts blinking.
3. Press OPTION until you set right status.
4. Press OK to confirm.
Warning is set to ON as default.