AEG L 61271 BI Kullanıcı Kılavuzu - Sayfa 24
Yıkayıcı AEG L 61271 BI için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG L 61271 BI 36 sayfaları. Washing machines
Ayrıca AEG L 61271 BI için: Kullanıcı Kılavuzu (36 sayfalar)
Sayfayı Yazdır
24 www.aeg.com
Problem
The machine does not
fill:
The machine fills then
empties immediately:
The machine does not
empty and/or does not
spin:
There is water on the
floor:
Possible cause/Solution
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose or the inlet valve filter are
blocked.
• Clean the water inlet filters. (See "Cleaning the
water inlet filters" for more details)
The door is not properly closed.
• Close the door firmly.
The end of the drain hose is too low.
• Refer to relevant paragraph in «Water drainage»
section.
The drain hose is squashed or kinked.
• Check the drain hose connection.
The drain filter is clogged.
• Clean the drain filter.
You have set an option or a programme that ends
with the water still in the tub or a that eliminates all
the spinning phases.
• Set the draining or the spinning programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
Too much detergent or unsuitable detergent (cre-
ates too much foam) has been used.
• Reduce the detergent quantity or use another
one.
Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this as
the water runs down the hose; check to see if it is
damp.
• Check the water inlet hose connection.
The drain or the inlet hose is damaged.
• Replace it with a new one.
The cap on the emergency emptying hose has not
been replaced or the filter has not been properly
screwed in after cleaning action.
• Refit the cap on the emergency emptying hose or
screw the filter fully in.