Fujitsu Lifebook NH570 Bios Kılavuzu - Sayfa 3

Dizüstü Bilgisayar Fujitsu Lifebook NH570 için çevrimiçi göz atın veya pdf Bios Kılavuzu indirin. Fujitsu Lifebook NH570 29 sayfaları. Lifebook n series
Ayrıca Fujitsu Lifebook NH570 için: Başlangıç Kılavuzu (9 sayfalar), Veri Sayfası (6 sayfalar)

Sayfayı Yazdır

Entering the Setup Utility After a Configuration

Change or System Failure

If there has been a change in the system configuration

that does not agree with the parameter settings stored in

BIOS memory, or there is a failure in the system, the

system beeps and/or displays an error message after the

Power On Self Test (POST). If the failure is not too

severe, it will give you the opportunity to modify the

settings of the setup utility, as described in the following

steps:

1. When you turn on or restart the computer there is a

beep and/or the following message appears on the

screen:

Error message - please run SETUP

program Press <F1> key to continue,

<F2> to run SETUP

2. If an error message is displayed on the screen, and

you want to continue with the boot process and start

the operating system anyway, press the [F1] key.

If your notebook emits a series of beeps

■

that sounds like a code and the display is

blank, refer to the Troubleshooting sec-

tion of your system Use's Guide. The

Troubleshooting Section includes a list of

error messages and their meanings.

■

If your data security settings require it,

you may be asked for a password before

the operating system will be opened.

3. If an error message is displayed on the screen, and

you want to enter the setup utility, press the [F2] key.

4. When the setup utility starts with a fault present, the

system displays the following message:

Warning!

Error message

[Continue]

5. Press any key to enter the setup utility. The system

will then display the Main Menu with current

parameters values.

S e t u p U t i l i t y