AEG L 87480 FL Kullanıcı Kılavuzu - Sayfa 27

Yıkayıcı AEG L 87480 FL için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG L 87480 FL 36 sayfaları.
Ayrıca AEG L 87480 FL için: Kullanıcı Kılavuzu (40 sayfalar), Kullanıcı Kılavuzu (40 sayfalar), Kullanıcı Kılavuzu (32 sayfalar)

Sayfayı Yazdır

Problem

The appliance fills

with water and

drain immediately.

The washing re-

sults are not satis-

factory.

After the check, activate the appliance.

The programme continues from the

point of interruption.

If the problem occurs again, contact the

service centre.

13. INSTALLATION

13.1 Fixing plate kit

(405517114)

Available from your authorized dealer.

13.2 Unpacking

Possible cause

The end of the drain

hose is too low.

The detergent you used

was not sufficient or cor-

rect.

You did not remove the

stubborn stains before

you wash the laundry.

Incorrect temperature

was set.

Too much laundry load.

Possible solution

Make sure that the drain hose is

in the correct position.

Increase the detergent quantity

or use a different one.

Use special products to remove

the stubborn stains.

Make sure that you set the cor-

rect temperature.

Decrease the laundry load.

If the display shows other alarm codes,

contact the service centre.

If you install the appliance on a plinth,

secure the appliance in the fixing plates.

Follow the instructions supplied with the

kit.

Use the gloves. Remove the external

film. If necessary, use a cutter.

ENGLISH