AEG L 87685 FL Kullanıcı Kılavuzu - Sayfa 24
Yıkayıcı AEG L 87685 FL için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG L 87685 FL 36 sayfaları.
Sayfayı Yazdır
24
When you drain the water with the
emergency drain procedure, you must
activate again the drain system:
1. Put 2 litres of water in the main wash
compartment of the detergent dis-
penser.
2. Start the programme to drain the
water.
FROST PRECAUTIONS
If the appliance is installed in an area
where the temperature can be less than
0 °C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
TROUBLE SHOOTER AND SERVICE
The start of the appliance does not oc-
cur or it stops during operation.
First try to find a solution to the prob-
lem (refer to the table). If not, contact
the service centre.
With some problems, the acoustic
signals operate and the display
shows an alarm code:
•
- The appliance does not fill
with water.
Problem
The appliance
does not fill with
water.
The appliance
does not drain the
water.
Possible cause
The water tap is closed.
The water inlet hose is
damaged.
The filters in the water in-
let hose is blocked .
The water tap is blocked
or is furred with lime-
scale.
The connection of the
water inlet hose is not
correct.
The water pressure is too
low.
The water drain hose is
damaged.
2. Close the water tap.
3. Remove the water inlet hose
4. Put the two ends of the inlet hose in
a container and let the water flow
out of the hose.
5. Empty the drain pump. Refer to the
emergency drain procedure
6. When the drain pump is empty, in-
stall the inlet hose again.
WARNING!
Make sure that the temperature
is more than 0 °C before you
use the appliance again.
The manufacturer is not respon-
sible for damages caused by
low temperatures.
•
- The appliance does not drain
the water.
•
- The appliance door is open or
not closed correctly.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
Possible solution
Open the water tap.
Make sure that the water inlet
hose has no damages.
Clean the filters. Refer to 'Care
and cleaning'.
Clean the water tap.
Make sure that the connection is
correct.
Contact your local water authori-
ty.
Make sure that the water drain
hose has no damages.