AEG L61470WDBI Kullanıcı Kılavuzu - Sayfa 26

Yıkayıcı AEG L61470WDBI için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG L61470WDBI 40 sayfaları.
Ayrıca AEG L61470WDBI için: Kullanıcı Kılavuzu (36 sayfalar)

Sayfayı Yazdır

www.aeg.com

Problem

The appliance does not

fill with water properly.

The appliance does not

drain the water.

The spin phase does not

operate or the washing

cycle lasts longer than

usually.

There is water on the

floor.

You cannot open the ap-

pliance door.

The appliance makes an

unusual noise.

Possible solution

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not too

low. For this information, contact your local water authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter of the inlet hose and the filter of

the valve are not clogged. Refer to "Care and cleaning".

• Make sure that the inlet hose has no kinks or bends.

• Make sure that the connection of the water inlet hose is

correct.

• Make sure that the drain hose is in the correct position. The

hose may be too low.

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

• Make sure that the drain filter is not clogged. Clean the fil-

ter, if necessary. Refer to 'Care and cleaning'.

• Make sure that the connection of the drain hose is correct.

• Set the drain programme if you set a programme without

drain phase.

• Set the drain programme if you set an option which ends

with water in the tub.

• Set the spin programme.

• Make sure that the drain filter is not clogged. Clean the fil-

ter, if necessary. Refer to 'Care and cleaning'.

• Adjust manually the items in the tub and start the spin

phase again. This problem may be caused by balance prob-

lems.

• Make sure that the couplings of the water hoses are tight

and there is not water leakages.

• Make sure that the drain hose have no damages.

• Make sure you use the correct detergent and the correct

quantity of it.

• Make sure you have replaced the emergency emptying cap

into the filter

• Make sure you have properly screwed the filter in after

cleaning.

• Make sure that the washing programme is finished.

• Set the drain or the spin programme if there is water in the

drum.

• Make sure the levelling of the appliance is correct. Refer to

'Installation'.

• Make sure that the packaging and/or the transit bolts are

removed. Refer to 'Installation'.

• Add more laundry in the drum. The load may be too small.