AEG L61470WDBI Kullanıcı Kılavuzu - Sayfa 18
Yıkayıcı AEG L61470WDBI için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG L61470WDBI 36 sayfaları.
Ayrıca AEG L61470WDBI için: Kullanıcı Kılavuzu (40 sayfalar)
Sayfayı Yazdır
18
www.aeg.com
• As the appliance calculates also
the duration of the anti-crease
and the cooling phases, the
programme time will
automatically increase by some
minutes.
2. Press Start/Pause button to start the
programme.
• The display shows regularly a new
time value.
• The indicator
If you set only 10 minutes of
drying, the appliance
performs only a cooling
phase.
If the laundry is not sufficient dry, set
again a short drying time.
11.3 End of the drying
programme
The appliance stops automatically.
12. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
12.1 Non-Stop programme
(Automatic washing & drying)
For NON-STOP programme the
recommended load size is 4 kg for
cotton and 2 kg for synthetic.
CAUTION!
Do not use a dosing
device/ball when carrying
out a washing and drying
programme.
1. Load the laundry one item at a time.
2. Put the detergent and the additives
in the appropriate compartment.
3. Turn the programme knob to the
required programme to switch the
machine on.
4. Set the available options.
is on.
• The acoustic signals operate (if they
are active).
• In the display
comes on.
• The indicator of the Start/Pause
button goes off.
• The last minutes of the drying cycle
the appliance performs a cooling and
anti-crease phase. The door is still
locked. The display show a flashing
When the door locked indicator
goes off, you can open the door.
1. Turn the programme knob to Off
position to deactivate the appliance.
After some minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
2. Remove the laundry from the
appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent
mildew and odours.
4. Close the water tap.
To have a good drying
performance do not exceed
the maximum drying loads
recommended in the user
manual. Do not set a spin
speed lower than the
automatic speed of the set
programme.
12.2 Washing & Timed Drying
To have a good drying the appliance
does not let you set a too low spin speed
for the items to be washed and dried.
1. Press the button Drying Time to set
the drying time value.
After some seconds the display shows
the final time value, that is the total
duration of the washing and drying
cycles (washing + drying + anti-crease +
cooling phases).
If you set only 10 minutes of
drying after washing, the
appliance calculates also the
duration of the anti-crease
and the cooling phases.
.