AEG L6FBF60488 Kullanıcı Kılavuzu - Sayfa 26
Yıkayıcı AEG L6FBF60488 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG L6FBF60488 40 sayfaları.
Sayfayı Yazdır
26
www.aeg.com
1. Press the Ein /Aus button to
deactivate the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last
selected programme. Turn
the programme dial to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
5. Close the water tap.
12.14 Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the water
of the last rinse, the programme is
completed, but:
• The display shows the indicator , the
option indicator
door locked indicator
indicator of the running phase
flashes.
• The drum still turns at regular
intervals to prevent the creases in the
laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Schleudern
button to decrease the spin speed
proposed by the appliance.
2. Touch the Start/Pause button:
• If you have set
drains the water and spins.
13. HINTS AND TIPS
WARNING!
Refer to Safety chapters.
or
and the
. The
, the appliance
• If you have set
only drains the water.
The option indicator
while the indicator
goes off.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the Ein /Aus button a few
seconds to deactivate the appliance.
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
12.15 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you touch the Start/
Pause button.
Press the button Ein /Aus to activate
the appliance again.
• After 5 minutes from the end of the
washing programme
Press the Ein /Aus button to activate
the appliance again.
The display shows the end of the last
set programme.
Turn the programme dial to set a new
cycle.
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
13.1 The laundry load
• Divide the laundry into: white,
coloured, synthetics, delicates and
wool.
, the appliance
or
goes out,
flashes and then