AEG L6FBJ841P Kullanıcı Kılavuzu - Sayfa 8
Yıkayıcı AEG L6FBJ841P için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG L6FBJ841P 40 sayfaları.
Sayfayı Yazdır
8
www.aeg.com
Level of protection against ingress of solid particles and
moisture ensured by the protective cover, except where
the low voltage equipment has no protection against mois‐
ture
Water supply pressure
1)
Water supply
Maximum Load
Spin Speed
1) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot
connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your do‐
mestic cold water storage system. Make sure not to exceed a distance of 5.02 m (16.5 ft) between the
appliance inlet hose and the bottom of the water storage tank.
2) Connect the water inlet hose to a water tap with a 3/4'' thread.
5. INSTALLATION
WARNING!
Refer to Safety chapters.
5.1 Unpacking
1. Open the door. Remove all the items
from the drum.
Accessories delivered
with the appliance may
vary depending on the
model.
2. Put the packaging element on the
floor behind the appliance and
carefully put it down onto its rear
side. Remove the polystyrene
protection from the bottom.
Minimum
Maximum
2)
Cotton
Maximum spin speed
IPX4
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)
Cold water
8 kg
1351 rpm
CAUTION!
Do not lay washing machine
on its front.
3. Put the appliance back into an
upright position. Remove the power
supply cable and the drain hose from
the hose holders.
1
2