Fujitsu PRIMEPOWER 800 Donanım Platformu Kılavuzu - Sayfa 11
Sunucu Fujitsu PRIMEPOWER 800 için çevrimiçi göz atın veya pdf Donanım Platformu Kılavuzu indirin. Fujitsu PRIMEPOWER 800 50 sayfaları. Operation for solaris 10 operating system
Sayfayı Yazdır
7.
Press the Eject button on the diskette drive unit, then eject the diskette.
WARNING messages of se driver
When a serial port receives a lot of data, such as when a large amount of text is pasted on a console screen
connected to a serial port, the console message "seN: Buffer overrun" (N means an instance number of se
driver) will be displayed and the data will be lost.
This is because the user process cannot read data fast enough.
The size of data pasted on a console screen should be 1024 bytes or less at a time.
Speed of reception depends on each user process.
1.2.3 Notes on PCI cards
How to install PCI cards
To install a new PCI card, follow the steps described below.
Also, when you remove the PCI card or change the slot, do the following steps.
For PRIMEPOWER 1
1.
Enter the OpenBoot environment.
# /usr/sbin/shutdown -y -g0 -i0 <Return>
2.
Enter the following command to stop the system in the OpenBoot environment at the next system
boot.
ok setenv auto-boot? false <Return>
3.
Turn off the power to the system.
ok power-off <Return>
4.
Install the PCI card to the system. (For more detailed information, refer to the manual attached to
the card.)
5.
After you turn on the power, the OK prompt will be displayed. Boot the system with the following
command.
ok setenv auto-boot? true <Return>
ok boot -r <Return>
Some of the PCI cards need driver software. If that is the case, use the following steps:
6.
Add driver software. (For more detailed information, refer to the manual attached to the card.)
7.
Enter the Open Boot Environment. Some of the manuals attached to the card may instruct "Reboot
your machine", which means to enter the Open Boot Environment with the following command.
# /usr/sbin/shutdown -y -g0 -i0 <Return>
8.
When the OK prompt is displayed, boot the system with the following command.
ok boot -r <Return>
For PRIMEPOWER 200/400/600
1.
If the system is running, turn off the power to the system with the following command:
# /usr/sbin/shutdown -y -g0 -i5 <Return>
2.
Install the PCI card to the system. (For more detailed information, refer to the manual attached to
the card.)
3.
Set the MODE switch on the operation panel to "MANUAL" mode and turn on the power.
4.
After you turn on the power, the OK prompt will be displayed. Boot the system with the following
command.
ok boot -r <Return>
5.
Return the MODE switch on the operation panel to "SECURE" mode.
Some of the PCI cards need driver software. If that is the case, use the following steps:
6.
Add driver software. (For more detailed information, refer to the manual attached to the card.)
5