AEG L7FBE84W Kullanıcı Kılavuzu - Sayfa 24
Yıkayıcı AEG L7FBE84W için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG L7FBE84W 40 sayfaları.
Sayfayı Yazdır
24
www.aeg.com
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Start/Pauze - Départ Pause
button to pause the appliance. The
related indicator flashes.
2. Touch the Startuitstel - Départ différé
button repeatedly until the display
shows
3. Touch the Start/Pauze - Départ Pause
button again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pauze - Départ Pause
button to pause the appliance. The
related indicator flashes.
2. Touch the Startuitstel - Départ différé
button repeatedly until the display
shows the desired delay time.
3. Touch the Start/Pauze - Départ Pause
button again to start the new
countdown.
10.8 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start/Pauze - Départ
Pause button, the maximum declared
load indicator goes off, the indicator
flashes, the ProSense starts the laundry
load detection:
1. The appliance detects the load in the
first 30 seconds: the indicator
the time dots flash, the drum
rotates shortly.
2. At the end of the load detection, the
indicator
dots stop flashing. The programme
duration will be adjusted accordingly
and could increase or decrease. After
further 30 seconds, the water filling
starts.
.
goes off and the time
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pauze - Départ Pause
button to start the programme again.
The ProSense phase can be repeated up
to three times (see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted depending on
the capacity of water
absorption of the fabrics.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
10.9 Programme phase
indicators
When the programme starts the indicator
of the running phase flashes and the
other phase indicators are steady on.
E.g. the washing or pre wash phase is
running:
When the phase ends the relevant
indicator stops flashing and is steady on.
and
The next phase indicator starts flashing.
E.g. the rinse phase is running:
If you select the Plus Steam the steam
phase indicators come on.
The steam phase is running:
.
.
is
.