Fujitsu Primergy TX300 S4 Kullanım Hakkında Notlar - Sayfa 2

Sunucu Fujitsu Primergy TX300 S4 için çevrimiçi göz atın veya pdf Kullanım Hakkında Notlar indirin. Fujitsu Primergy TX300 S4 4 sayfaları. Pre-attached rack conversion kit
Ayrıca Fujitsu Primergy TX300 S4 için: Sistem Yapılandırma ve Sipariş Bilgileri Kılavuzu (17 sayfalar), Başlangıç Kılavuzu (8 sayfalar), Yükleme (3 sayfalar)

Sayfayı Yazdır

Fujitsu Primergy TX300 S4 Kullanım Hakkında Notlar

[Remedy]

Even if the message is recorded due to the delay in the processing to initialize the ServerView

Remote Connector service, the processing continues. The service is automatically started after

the completion of the initialization, so no special action is required.

※ ServerView Remote Connector service is used with the following ServerView functions. Even if this

service is not active, no other functions are affected.

- Performance Manager

Power

Monitor

Supplementary Information: How to Confirm

Follow either of the procedures below to confirm whether the ServerView Remote Connector service is

running normally.

1) When Performance Manager is used

− Start the Performance Manager from the ServerView S2.

− Select the server for which you want to confirm the ServerView Remote Connector service

operation from the left side frame.

− Select the [Report View] tab.

− Select any report, and click on the [Show >>] button.

If the graphic is displayed, the ServerView Remote Connector service is running normally and no change is

required. When the service is not running normally, the following dialog is displayed.

Note: It is necessary to make the report setting beforehand.

For the usage of Performance Manager, refer to "ServerView User's Guide".

2) When Power Monitor is used

− Start the Power Monitor from the ServerView S2.

− Select the server for which you want to confirm the ServerView Remote Connector service operation

from the left side frame.

− Select the [Data] tab.

If the graphic is displayed, ServerView Remote Connector service is running normally and no change is

required. When the service is not running normally, the following dialogs are displayed.

A) The following dialog box is displayed and left open.

B) After the dialog in (A), the following window is displayed.

Note: For the usage of Power Monitor, refer to "ServerView User's Guide".

2 / 4