Fujitsu SPARC Enterprise M3000 Başlangıç Kılavuzu - Sayfa 4
Sunucu Fujitsu SPARC Enterprise M3000 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Fujitsu SPARC Enterprise M3000 8 sayfaları.
Ayrıca Fujitsu SPARC Enterprise M3000 için: Ürün Notları (38 sayfalar), Güvenlik ve Uyumluluk Kılavuzu (34 sayfalar), Ürün Notları (42 sayfalar)
Sayfayı Yazdır
8. The following steps will log in to the XSCF Shell and initialize the XSCF settings.
XSCF is a system control facility to set up and control the server. To initialize the XSCF settings, use the
XSCF default user account.
a. Set the mode switch on the operator panel to the Service mode (
The key for the mode switch is supplied with the server.
Operator Panel
FIGURE 2
Location Number
1
2
3
4
5
b. Turn the power source circuit breaker to "ON".
After the power is turned on, the server starts the XSCF initialization that can take up to 5 or more
minutes. When the initialization completes, the XSCF STANDBY LED (
lights.
c. After the XSCF initialization completes, enter default at the login prompt.
login: default
d. Operate the mode switch within one minute according to the messages to change the mode switch.
A login authentication timeout will occur after one minute.
Change the panel mode switch to Locked and press return...
Leave it in that position for at least 5 seconds.
Change the panel mode switch to Service, and press return...
Name
POWER LED
XSCF STANDBY LED
CHECK LED
Power button
Mode switch (Key switch)
4
).
1
2
3
4
5
) on the operator panel