Fujitsu SPARC Enterprise M5000 Tamamlayıcı Kılavuz - Sayfa 24
Sunucu Fujitsu SPARC Enterprise M5000 için çevrimiçi göz atın veya pdf Tamamlayıcı Kılavuz indirin. Fujitsu SPARC Enterprise M5000 36 sayfaları. Rci build procedure
Ayrıca Fujitsu SPARC Enterprise M5000 için: Özellikler Kılavuz (30 sayfalar), Ürün Notları (44 sayfalar), Başlangıç Kılavuzu (4 sayfalar)
Sayfayı Yazdır
CHAPTER 1 RCI Build Procedure
1.3.2
New setup of two RCI Hosts
1
Log in to the XSCF Shell.
2
On main unit A, execute the setrci -c stat command to display the RCI status.
XSCF> setrci -c stat
HOST
address 000f7fff
Inactive
The command completed successfully
3
Verify that the RCI address is 000f7fff.
Remarks: 000f7fff is the default value of the RCI address. If the default value is not
set, execute the setrci -c init command to initialize the value.
If the system is powered off, you can use the setrci -c init command.
XSCF> setrci -c init
The command completed successfully
4
In a similar manner, display the RCI status of main unit B to verify that the RCI
address is 000f7fff.
5
Connect the main unit and I/O units with RCI cables (see
Connect an RCI branching connector to each of the RCI ports, and connect them with
RCI cables by using a daisy-chain connection.
Connect an RCI terminating resistor to the branching connector at either end of the
RCI connection. Refer to
6
Turn on the AC input to all the RCI device which are in the RCI connection.
1-6
RCI
Host A
RCI I/O unit
Figure 1.6 New setup of two RCI Hosts
Section 1.3.5, "Connection of RCI."
RCI
Host B
RCI I/O unit
Figure
1.6).
C120-E361-04EN