Fujitsu fi-4530C Başlarken - Sayfa 22

Tarayıcı Fujitsu fi-4530C için çevrimiçi göz atın veya pdf Başlarken indirin. Fujitsu fi-4530C 27 sayfaları. Image scanner
Ayrıca Fujitsu fi-4530C için: Kurulum Prosedürleri Kılavuzu (7 sayfalar), Kurulum Prosedürleri Kılavuzu (9 sayfalar), Broşür ve Teknik Özellikler (2 sayfalar), Kurulum Prosedürleri (3 sayfalar), Sarf Malzemesi Değiştirme ve Temizleme Talimatları (14 sayfalar), Temizlik Talimatları Kılavuzu (13 sayfalar), Temizlik Talimatları (2 sayfalar), Kullanım Kılavuzu (10 sayfalar), Kurulum Prosedürü (5 sayfalar)

Sayfayı Yazdır
Fujitsu fi-4530C Başlarken
Appendix1

■ Troubleshooting checklist

Symptom
Scanner does not turn on.
Scanning does not start.
Vertical lines appear in the
printed image.
The printed scanned image
shifts or is distorted.
Quality of scanned image
is unsatisfactory.
TROUBLESHOOTING
Check this item
Have you pushed the power button?
Are the AC cable and AC adapter
properly connected to the scanner?
Is Windows normally started up?
Are the documents loaded correctly on
the ADF paper chute?
Is the ADF closed completely?
Is the USB cable or SCSI cable prop-
erly connected?
(When using SCSI interface) Is SCSI
ID set correctly?
Does the Function No. display indi-
cates an alarm or an error?
Does the alarm state remain displayed
even after the scanner has been turned
off and back on again?
Is the glass dirty?
Are the documents loaded correctly?
Are the glass or sheet guides (a white
location) clean?
fi-4530C Image Scanner Getting Started
Remedy
Push the power button.
Correctly connect the AC cable and the AC
adapter.
Disconnect the AC cable and the AC adapter
from the scanner, then connect them again.
If this does not restore the power supply, con-
tact the store where you purchased the scanner
or an authorized FUJITSU scanner service pro-
vider.
Push the power button again after completely
starting up Windows.
Load the document correctly on ADF paper
chute.
Close the ADF completely.
Correctly connect the cable. (When a USB hub
is used, check the hub's power supply.)
Set SCSI ID correctly by SCSI ID switch on
rear of scanner.
When the Function No. display indicates an
alarm or an error, refer to the "Chapter 5.
TROUBLESHOOTING" in the fi-4530C Oper-
ator's Guide for removing the alarm or the
error.
Turn off and on the power button.
If this does not eliminate the alarm state, con-
tact the store where you purchased the scanner
or an authorized FUJITSU scanner service pro-
vider.
Clean the glass following the instructions in
Operator's Guide "3. Daily Care".
Load the documents correctly.
Clean dirty locations.
AP-1