Fujitsu FI-5530C2 Başlangıç Kılavuzu - Sayfa 14

Tarayıcı Fujitsu FI-5530C2 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Fujitsu FI-5530C2 27 sayfaları. Image scanner
Ayrıca Fujitsu FI-5530C2 için: Başlarken (28 sayfalar), Kurulum Prosedürleri Kılavuzu (6 sayfalar), Teknik Özellikler (2 sayfalar), Başlangıç Kılavuzu (11 sayfalar), Temizlik Talimatları (2 sayfalar), Temizlik Talimatları (2 sayfalar), Başlarken (11 sayfalar)

3. If the scanner is automatically detected,

[Found New Hardware Wizard] or [Add/

Remove Hardware Wizard] dialog box will

appear. Click the [Cancel] button to close the

Wizard dialog box.

4. Insert the Setup CD-ROM into the CD drive.

⇒

appears.

This screen may not appear if the

ATTENTION

"AutoPlay" setting is set to off. In this case,

find "Install.exe" in the CD-ROM using

"Explore" or "My Computer" to start instal-

lation.

5. Click [INSTALL PRODUCTS], and then click

[TWAIN Driver].

6. The Error Recovery Guide Installation dialog

box appears.

Error Recovery Guide is an application with

which you can view on-screen information for

troubleshooting errors that may occur in the

scanner. This guide helps solve problems, so

select [Yes] to install it. You may also choose

to install it later.

After you select [Yes] for installing Error

ATTENTION

Recovery Guide, the [Choose Setup Lan-

guage] dialog box appears. Select a lan-

guage and follow the on-screen

instructions. The Error Recovery Guide dia-

log box is automatically displayed when the

installation is complete. Wait until the instal-

lation of the TWAIN driver starts.

7. Select a language for the installation on the

[Choose Setup Language] dialog box, and then

click the [Next] button.

8. Install the driver, following the on-screen

instructions.

9. When you see the [InstallShield Wizard Com-

plete] dialog box, click the [Finish] button.

Depending on the state of the operating system, the

computer may shut down and restart. In this case, the

computer detects the scanner when it starts up. Do not

remove the Setup CD-ROM from the CD drive until the

computer completely starts up again.