Fujitsu FI-5900C Sarf Malzemesi Değiştirme ve Temizleme Talimatları - Sayfa 19

Tarayıcı Fujitsu FI-5900C için çevrimiçi göz atın veya pdf Sarf Malzemesi Değiştirme ve Temizleme Talimatları indirin. Fujitsu FI-5900C 24 sayfaları. Consumable replacement and cleaning instructions
Ayrıca Fujitsu FI-5900C için: Başlarken (30 sayfalar), Kurulum Prosedürleri Kılavuzu (7 sayfalar), Kurulum Prosedürleri Kılavuzu (9 sayfalar), Kurulum Prosedürleri (3 sayfalar), Broşür ve Teknik Özellikler (2 sayfalar), Tamamlayıcı Kılavuz (4 sayfalar), Başlarken (30 sayfalar), Broşür ve Teknik Özellikler (4 sayfalar), Değiştirme Prosedürü (22 sayfalar), Temizlik Talimatları (2 sayfalar)

Sayfayı Yazdır
Fujitsu FI-5900C Sarf Malzemesi Değiştirme ve Temizleme Talimatları
C
P
LEANING THE
INCH AND
It is very important to clean the scanner pinch and feed rollers on a
regular basis to avoid paper feeding problems. These rollers should be
cleaned every 10,000 sheets. More frequent cleaning will be required
if scanning paper with a large amount of printing, documents filled
out in pencil, or carbonless multipart forms.
Roller Types
The fi-5900C and fi-5950
Scanners have nine sets of
Pinch and Feed Rollers with
two rollers on each shaft. The
Pinch Rollers are the upper set
of rollers (grey rollers in
drawing to the right). The Feed
Rollers are the lower set of
rollers (black rollers in the
drawing to the right).
NOTE!
•
The fi-5900C Scanner can have either Rubber or Metal Feed Rollers
installed. It is very important to know what rollers are installed because
the fluids used to clean the different type of rollers is different.
•
All fi-5950 Scanners have Rubber Feed Rollers installed.
Identifying Rubber Rollers
•
Any fi-5900C Scanner, Serial Number 100001 and above has Rubber
Rollers installed.
•
Any scanner that was upgraded to Rubber Rollers will have a
"Rubber Roller Label installed on the front of the scanner.
The table below lists the cleaners for each roller type.
Location
Upper Pinch Rollers
Lower Feed Rollers (Rubber) *
Lower Feed Rollers (Metal)
*
IMPORTANT NOTE!
If you have Rubber Lower Feed Rollers it is very important to
clean them with F1 Cleaner only! Using F2 Cleaner will damage
the rollers. The end-user will be responsible for replacing the
rollers.
Notes:
•
After cleaning the rollers make sure the cleaning fluid has
dried completely before feeding paper.
•
Do not use F2 Cleaner on the Upper Pinch Rollers.
fi-5900C & fi-5950 C
F
R
EED
OLLERS
Pinch Rollers
Tools
Cleaning Sheets
Cloth & F1 Cleaner or
Isopropyl Alcohol
Cloth with F2 Cleaner
R
ONSUMABLE
EPLACEMENT AND
Feed Rollers
Feed Rollers
Frequency
Every 10,000 Sheets
Every 10,000 Sheets
C
I
LEANING
NSTRUCTIONS
19