Fujitsu M4097D-VRS Kurulum Prosedürleri - Sayfa 2
Tarayıcı Fujitsu M4097D-VRS için çevrimiçi göz atın veya pdf Kurulum Prosedürleri indirin. Fujitsu M4097D-VRS 3 sayfaları. Scsi scanner with vrs (gsa-1) for windows 2000 / xp
Ayrıca Fujitsu M4097D-VRS için: Kurulum Prosedürleri (3 sayfalar)
Sayfayı Yazdır
Fujitsu SCSI
Scanner Installation Procedures with
The M4097D has the "L" bracket shipping lock.
1. Slide the scanner to its side as shown in figure below.
2. Unscrew the retainer screw and remove the shipping bracket.
3. Place the shipping bracket in the "use position" slot and secure it with the
retainer screw (see figure below)
4. Place scanner back in its normal position
Step D: Connecting the Scanner.
Warning! Before proceeding ensure that the power is off when connecting or
disconnecting the SCSI cable to the scanner or workstation. Failure to follow the
procedure above could result in damage to the SCSI card, scanner, and/or your system.
Termination and the SCSI ID's for both the M4097D and M4099D VRS
scanners are handled automatically. Connect the SCSI cable to the Kofax
controller and to the Wide SCSI (68-pin) port on the scanner. Ensure all
connections are securely fastened.
Connect the power cord to the scanner and a wall outlet. Boot up the host PC
first and then turn on the scanner. Listen to and watch the back of the
Rev010807L
Windows 2000 / XP
VRS (GSA-1)
Page 2 of 3