Brother DCP-7045N Hızlı Kurulum Kılavuzu - Sayfa 29
Yazdırma Sunucusu Brother DCP-7045N için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Brother DCP-7045N 32 sayfaları.
Ayrıca Brother DCP-7045N için: Hızlı Kurulum Kılavuzu (18 sayfalar), Hızlı Kurulum Kılavuzu (32 sayfalar)
Sayfayı Yazdır
Web Based Management
3
(web browser)
The Brother print server is equipped with a web server
that allows you to monitor its status or change some
of its configuration settings, using HTTP (Hyper Text
Transfer Protocol).
Note
• The User Name is 'admin' and the default
password is 'access'. You can use a web browser
to change this password.
• We recommend Microsoft
(or higher) or Firefox 1.0 (or higher) for Windows
and Safari 1.0 for Macintosh. Please also make
sure that JavaScript and Cookies are always
enabled in whichever browser you use. We
recommend you upgrade to Safari 1.2 or higher to
enable JavaScript. To use a web browser, you will
need to know the IP address of the print server.
1
Open your browser.
2
Type http:// printer_ip_address /into your
browser (Where "printer_ip_address" is the IP
address of the printer or the print server name).
For example http://192.168.1.2/
See Chapter 8 of the Network User's Guide.
®
®
Internet Explorer
6.0
®
For Network Users
Restoring the network
4
settings to factory default
To restore all network settings of the internal
Print/Scan server to factory default, please follow the
steps below.
1
Make sure the machine is not in use, then
disconnect all the cables from the machine
(except power cable).
2
Press Menu and
Press OK.
3
Press
or
to select
0.Factory Reset.
Press OK.
4
Press
to select Reset.
5
Press
to select Yes.
6
The machine will restart. Re-connect cables
once this is complete.
Print the Network
5
Configuration List
You can print the Network Configuration List to
confirm the current network settings. To print the
Network Configuration List:
1
Make sure that the front cover is closed and the
power cord is plugged in.
2
Turn on the machine and wait until the machine
is in the Ready state.
3
Press Menu and
1.General Setup.
Press OK.
4
Press
or
to select
7.Network Config.
Press OK.
5
Press Start.
or
to select 4.LAN.
or
to select
27