AEG LTR75STEAM Kullanıcı Kılavuzu - Sayfa 25

Yıkayıcı AEG LTR75STEAM için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG LTR75STEAM 40 sayfaları.

AEG LTR75STEAM Kullanıcı Kılavuzu
The ProSense is not available with some
programmes, such as Wol/Zijde - Laine/
Soie, programmes with short cycles and
without washing phase.
11.13 Opening the Lid when the
programme operates
CAUTION!
If the temperature and level of the water
in the drum are too high, the
indicator stays on and you cannot open
the lid.
To open the lid proceed as follows:
1. Press the button Aan/Uit - Marche/Arrêt
for some seconds to deactivate the
appliance.
2. Wait for some minutes and then open
carefully the lid.
3. Close the lid.
4. Activate the appliance and set the
programme again.
11.14 Opening the Lid when the
delay start is active
While the delay start operates, the appliance
lid is locked.
To open the appliance lid:
1. Press button Start/Pauze - Départ/Pause.
The
indicator goes off.
2. Open the appliance lid.
3. Close the lid and press button Start/
Pauze - Départ/Pause.
The delay start continues.
11.15 End of cycle
When the programme has finished, the
appliance stops automatically. The acoustic
signal operates (if it is active).
In the display
comes on and the lid locked
indicator
goes off.
The indicator of Start/Pauze - Départ/Pause
button goes off.
1. Press button Aan/Uit - Marche/Arrêt to
deactivate the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the appliance again,
the display show the end of the last set
programme. Turn the programme knob to
set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent mildew and
odours
11.16 Draining water out after end
of cycle
The washing programme is completed,
but there is water in the drum:
The drum turns regularly to prevent the
creases in the laundry.
The lid lock indicator
locked.
You must drain the water to open the lid:
1. If necessary, decrease the spin speed.
2. Press the Start/Pauze - Départ/Pause
button.
The appliance drains the water and spins.
3. When the programme is completed and
the door lock indicator
can open the door .
4. Press Aan/Uit - Marche/Arrêt some
seconds to deactivate the appliance.
The appliance drains and spins
automatically after approximately18
hours.
11.17 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease the
energy consumption when:
• You do not use the appliance for 5
minutes before you press the button Start/
Pauze - Départ/Pause
Press the Aan/Uit - Marche/Arrêt
to activate the appliance again.
is on. The lid stays
goes off, you
button
ENGLISH
25