Fujitsu ETERNUS8000 1100 Manuel - Sayfa 8

Depolama Fujitsu ETERNUS8000 1100 için çevrimiçi göz atın veya pdf Manuel indirin. Fujitsu ETERNUS8000 1100 21 sayfaları. Disk storage systems (fibre channel) for oracle solaris
Ayrıca Fujitsu ETERNUS8000 1100 için: Manuel (28 sayfalar), Sunucu Bağlantı Kılavuzu (25 sayfalar), Sunucu Bağlantı Kılavuzu (32 sayfalar), Bağlantı Kılavuzu (19 sayfalar)

Sayfayı Yazdır

Chapter 3

The MPxIO set up procedure is common to all ETERNUS2000, ETERNUS4000, and

ETERNUS8000 Disk storage systems, but some settings vary depending on the Solaris OS ver-

sion.

Set up MPxIO according to the Solaris OS version being used.

3.1

Solaris 10 OS

3.1.1

Disabling MPxIO on Some Paths

When multipathing is not required for the specific LUN, use the following procedure to add phys-

ical paths for the relevant device to the "/kernel/drv/fp.conf" file in order to disable the multipath

function for the device.

Disabling the multipath function is not necessary when multipathing is to be set up for all the

LUNs that are recognized by the OS. In these cases, proceed to

9).

P3AM-2722-04ENZ0

ETERNUS Disk storage systems Server Connection Guide for Oracle Solaris

Setting Up MPxIO

If this setting is omitted, multipathing is set up for all LUNs recognized by

the OS.

MPxIO must be disabled for the paths of connected devices that MPxIO

does not support (such as a tape device).

Procedure

Use the "cat" command (etc.) to check the "/etc/path_to_inst" file and identify the

physical pathname of the device for which multipathing is not required.

In this example, the physical path is "/pci@8,600000/SUNW,qlc@2"

# cat /etc/path_to_inst

"/pci@8,600000/SUNW,qlc@2" 0 "qlc"

"/pci@8,600000/SUNW,qlc@2/fp@0,0" 5 "fp"

"/pci@8,600000/SUNW,qlc@2/fp@0,0/ssd@w500000e0113ce2e1,0" 5 "ssd"

Physical path

Add the following line to the "/kernel/drv/fp.conf" file using the "vi" command.

name="fp" parent="Physical path" port=0 mpxio-disable="yes";

"3.1.2 Enabling MPxIO" (page