AEG PowerCare LR86CB86 Kullanıcı Kılavuzu - Sayfa 37

Yıkayıcı AEG PowerCare LR86CB86 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG PowerCare LR86CB86 48 sayfaları.

Sayfayı Yazdır

1. Put 2 litres of water in the main wash

compartment of the detergent

dispenser.

2. Start the programme to drain the

water.

13.12 Frost precautions

If the appliance is installed in an area

where the temperature can reach the

values around 0° C or drop below,

remove the remaining water from the

inlet hose and the drain pump.

1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.

14. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

14.1 Alarm Codes and Possible failures

The appliance does not start or it stops during operation. First try to find a solution to the

problem (refer to the tables).

WARNING!

Deactivate the appliance before carrying out any check.

With some problems, the display shows an alarm code and the

Start / Pause

If the appliance is overloaded, remove some items

from the drum and/or keep pressed the door while

touching the Start / Pause button until the indicator

Problem

button may flash continuously:

stops flashing (see the picture below).

Possible solution

3. Put the two ends of the inlet hose in

a container and let the water flow out

of the hose.

4. Empty the drain pump. Refer to the

emergency drain procedure.

5. When the drain pump is empty,

install the inlet hose again.

WARNING!

Make sure that the

temperature is higher than

0 °C before you use the

appliance again.

The manufacturer is not

responsible for damages

caused by low temperatures.

ENGLISH