AEG ProSense 6000 Series Kullanıcı Kılavuzu - Sayfa 5

Yıkayıcı AEG ProSense 6000 Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG ProSense 6000 Series 40 sayfaları.

Sayfayı Yazdır

2. SAFETY INSTRUCTIONS

2.1 Installation

The installation must comply with

relevant national regulations.

• Remove all the packaging and the transit

bolts including rubber bush with plastic

spacer.

• Keep the transit bolts in a safe place. If the

appliance is to be moved in the future they

must be reattached to lock the drum to

prevent an internal damage.

• Always take care when moving the

appliance as it is heavy. Always use safety

gloves and enclosed footwear.

• Follow the installation instructions supplied

with the appliance.

• Do not install or use a damaged

appliance.

• Do not install or use the appliance where

the temperature can be less than 0°C or

where it is exposed to the weather.

• The floor area on which the appliance is to

be installed must be flat, stable, heat

resistant and clean.

• Make sure that there is air circulation

between the appliance and the floor.

• When the appliance is in its permanent

position, check if it is levelled correctly

with the aid of a spirit level. If it is not,

adjust the feet accordingly.

• Do not install the appliance directly above

a floor drain.

• Do not spray water on the appliance and

do not expose it to excessive humidity.

• Do not install the appliance where the

appliance door cannot be fully opened.

• Do not put a closed container to collect

possible water leakage under the

appliance. Contact the Authorised Service

Centre to ensure which accessories can

be used.

2.2 Electrical connection

WARNING!

Risk of fire and electric shock.

• WARNING: This appliance is designed to

be installed / connected to a grounding

connection in the building.

• Always use a correctly installed

shockproof socket.

• Make sure that the parameters on the

rating plate are compatible with the

electrical ratings of the mains power

supply.

• Do not use multi-plug adapters and

extension cables.

• Make sure not to cause damage to the

mains plug and to the mains cable. Should

the mains cable need to be replaced, this

must be carried out by our Authorised

Service Centre.

• Connect the mains plug to the mains

socket only at the end of the installation.

Make sure that there is access to the

mains plug after the installation.

• Do not touch the mains cable or the mains

plug with wet hands.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

2.3 Water connection

• The inlet water shall not exceed 25 °C.

• Do not cause damage to the water hoses.

• Before connection to new pipes, pipes not

used for a long time, where repair work

has been carried out or new devices fitted

(water meters, etc.), let the water flow until

it is clean and clear.

• Ensure that there are no visible water

leaks during and after the first use of the

appliance.

• Do not use an extension hose if the inlet

hose is too short. Contact the Authorised

Service Centre for the replacement of the

inlet hose.

• When unpacking the appliance, It is

possible to see water flowing from the

drain hose. This is due to the testing of the

appliance with the use of water in the

factory.

• You can extend the drain hose to

maximum 400 cm. Contact the Authorised

Service Centre for the other drain hose

and the extension.

ENGLISH