Brother 2 Manuel - Sayfa 14

Yazılım Brother 2 için çevrimiçi göz atın veya pdf Manuel indirin. Brother 2 39 sayfaları. Hewlett-packard laser printer user guide
Ayrıca Brother 2 için: Kullanıcı Kılavuzu (15 sayfalar)

Sayfayı Yazdır

Make sure that the trimmer blade is positioned at the

right end of the trimmer.

a Trimmer blade

b Trimmer

Note

• The trimmer blade can cut material only when it is slid from

the right end of the trimmer. It cannot cut if it is slid from

any location other than the right end.

While keeping the left edge of the material aligned with

the rolled material guide, firmly press the trimmer down

on the right side of the material. While holding them in

place, slide the trimmer blade from right to left to cut off

the material.

Slide the trimmer blade while pressing down gently.

a Rolled material guide

b Trimmer

c Trimmer blade

Note

If the material does not cut easily:

• If cutting does not start smoothly, for example, if the

material catches on the blade, instead of sliding the blade

with excessive force, refer to the following and try again.

Sliding the trimmer blade with excessive force may cause

damage.

If the material is not very pliable, firmly press the

trimmer down on the right side of the material.

If the material is fairly pliable and has a strong curl,

firmly press the trimmer down at the center.

Return the trimmer blade to the right end of the trimmer,

and then remove the trimmer.

Remove any material that has been trimmed off.

a Trimmer

Memo

• The removed trimmer can be stored at the front of the roll

holder.